QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

11 – Simple Network Management Protocol ConfigurationManaging the SNMP Version 3 ConfigurationSManaging the SNMP Version 3 ConfigurationSNMP version 3 is an interoperable standards-based protocol for networkmanagement. SNMP version 3 provides secure access to devices by acombination of packet authentication and encryption over the network. SNMPversion 3 provides the following security features:• Message integrity—ensures that packets have not been altered• Authentication—ensures that the packet is coming from a valid source• Encryption—ensures that packet contents cannot be read by anunauthorized sourceTo configure SNMP version 3, you must enable SNMP version 3 on the switch andcreate one or more SNMP version 3 user accounts. To enable SNMP version 3,enter the Set Setup SNMP Common command and set the SNMPv3Enabledparameter to True:QLogic8GbT #> admin startQLogic8GbT (admin) #> set setup snmp commonA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Current Values:SnmpEnabled TrueContactLocationReadCommunity publicWriteCommunity privateAuthFailureTrap FalseProxyEnabled TrueSNMPv3Enabled FalseNew Value (press ENTER to not specify value, 'q' to quit):SnmpEnabled (True / False) :Contact (string, max=64 chars) :Location (string, max=64 chars) :ReadCommunity (string, max=32 chars) :WriteCommunity (string, max=32 chars) :AuthFailureTrap (True / False) :ProxyEnabled (True / False) :SNMPv3Enabled (True / False) : tDo you want to save and activate this snmp setup? (y/n): [n] y11-6 59245-01 A