QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

11 – Simple Network Management Protocol ConfigurationModifying the SNMP ConfigurationSModifying the SNMP ConfigurationEnter the Set Setup SNMP command in an Admin session to configure SNMP onthe switch. There are two groups of configuration parameters. One group iscommon to all traps. The second group is trap specific. You can configure bothgroups of parameters for all SNMP traps, or you can configure the common andtrap-specific parameters separately. Refer to Table 12-20 for SNMP parametersdescriptions.The following example configures the common SNMP trap configurationparameters:QLogic8GbT (admin) #> set setup snmp commonA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Current Values:SnmpEnabled TrueContactLocationReadCommunity publicWriteCommunity privateAuthFailureTrap FalseProxyEnabled TrueSNMPv3Enabled FalseNew Value (press ENTER to not specify value, 'q' to quit):SnmpEnabled (True / False) :Contact (string, max=64 chars) :Location (string, max=64 chars) :ReadCommunity (string, max=32 chars) :WriteCommunity (string, max=32 chars) :AuthFailureTrap (True / False) :ProxyEnabled (True / False) :SNMPv3Enabled (True / False) :Do you want to save and activate this snmp setup? (y/n): [n]11-4 59245-01 A