QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

11 – Simple Network Management Protocol ConfigurationManaging the SNMP ServiceSEnter the command to enable SNMP as shown in the following example:QLogic8GbT #> admin startQLogic8GbT (admin) #> set setup servicesA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.PLEASE NOTE:-----------* Further configuration may be required after enabling a service.* If services are disabled, the connection to the switch may be lost.* When enabling SSL, please verify that the date/time settingson this switch and the workstation from where the SSL connectionwill be started match, and then a new certificate may need to becreated to ensure a secure connection to this switch.TelnetEnabled (True / False) [True ]SSHEnabled (True / False) [False]GUIMgmtEnabled (True / False) [True ]SSLEnabled (True / False) [False]EmbeddedGUIEnabled (True / False) [True ]SNMPEnabled (True / False) [True ]NTPEnabled (True / False) [False]FTPEnabled (True / False) [True ]CallHomeEnabled (True / False) [True ]Do you want to save and activate this services setup? (y/n): [y]You can display the SNMPEnabled parameters using the Show Setup SNMP orShow Setup Services commands.11-2 59245-01 A