QLogic 8 Gb Intelligent Pass-thru Module for IBM BladeCenter ...

9 – Event Log ConfigurationManaging the Event Log ConfigurationSManaging the Event Log ConfigurationManaging the Event Log Configuration consists of the following tasks:• Configure the Event Log• Display the Event Log Configuration• Restore the Event Log ConfigurationConfigure the Event LogYou can customize what events are recorded in the I/O module event logaccording to component, severity level, and port. Enter the Set Log Component,Set Log Level, and Set Log Port commands to filter the events to be recorded.You can choose from the following component events:• Port events• Switch management events• Simple Network Management Protocol (SNMP) events• Command Line Interface eventsThe following example configures the event log to record switch managementevents with warning and critical severity levels associated with ports 0, 15, 16, and17. Entering the Set Log Save command ensures that this configuration ispreserved across I/O module resets.QLogic8GbT (admin) #> set log component switchQLogic8GbT (admin) #> set log level warnQLogic8GbT (admin) #> set log port 0 15-17QLogic8GbT (admin) #> set log saveDisplay the Event Log ConfigurationEnter the Show Log Settings command to display all event log configurationsettings as shown in the following example:QLogic8GbT #> show log settingsCurrent settings for log------------------------StartedTrueFilterComponent Switch Blade Port Snmp CLIFilterLevel InfoDisplayLevel CriticalFilterPort 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 199-4 59245-01 A