7. operating the multipress - Grass

7. OPERATING THE MULTIPRESS7-703 Drilling structural shelf support holes Illustrations 7-703-01 and 7-703-02(e. g. Fixograss 9000)Required Equipment:- xx variable speed drill bit 8/19 mm Ø (6/15 mm Ø ), right or left- Hold-down plateMachine Set-Up:- Turn off the machine at the main switch in the switchgear cabinet.- Set the travel limit for the vertical bore head (see section 7-305), if necessary.The travel limit must be turned off.- Remove all quick-change drill chucks and drill bits from the horizontal gearbox. (See section 7-202).- Fix the new quick-change drill chucks and drill bits to the horizontal gearbox. (See section 7-202).- See illustration 7-701-01 for placement of the spindles.- Set the drilling depth, if necessary, in accordance with the instructions given in section 7-401. Check theproduct documentation for drilling depth specifications. The preset revolver stop may be used.- Set the drilling height, if necessary, in accordance with the instructions given in section 7-402. Check theproduct documentation for drilling height specifications.- Set the horizontal Multipress drilling speed, if necessary, in accordance with the instructions given insection 7-403.- Set the travel limit for the horizontal bore head, if necessary, in accordance with theinstructions given in section 7-404.- Set the side stops, in accordance with the instructions given in section 7-501 and the stop adjustmentgauge in accordance with the instructions given in section 7-502.- Adjust the hold-down device, if necessary, in accordance with the instructions given in section 7-504.- Mount the hold-down plate on the insertion die arm.- Turn on the main switch again. The Multipress is now ready to operate.Operating the Multipress:- Place the workpiece on the machine table with one hand pressed against the stop pins and side stop.- Swing the insertion die arm down to the stop.Caution: The distance between the hold-down plate and the workpiece to be clamped must be no morethan 6 mm.If the distance is more than 6 mm, a thicker hold-down plate must be used.- Clamp the workpiece with the hold-down device. The monitor switch for clamping workpieces is shown as“3” on illustration 4-004-01.- Press the horizontal bore head start button “4” (illustration 4-004-01) with second hand until the bore headreaches the drilling depth set with the revolver stop “3” (illustration 7-401-01).- Loosen the workpiece. The monitor switch for clamping workpieces is shown as “3” onillustration 4-004-01.- If additional bore holes are needed and these cannot be completed in one work cycle, slide the workpieceto the next stop and repeat the entire process.Caution:While the machine is being operated: keep hands clear of the danger area around the hold-down device,the insertion die arm and the gearbox. The safety information given in section 2 is to be followed wheneverthe machine is being operated.The star in your cabinet87