7. operating the multipress - Grass

7. OPERATING THE MULTIPRESS7-608 Drilling handle bore holes Illustrations 7-608-01 and 7-608-02Required Equipment:- 2 (1) drill bit Ø 5 (3) mm, right- (1) drill bit Ø 5 (3) mm, left- 1 wooden (or similar material) base, about 5 mm thick- 2 machine table inserts for front panels that are smaller in height than 130 mmThe numbers in brackets correspond to the 32 mm and 96 mm hole spacingsMachine Set-Up- Turn off the machine at the main switch in the switchgear cabinet.- Lift up the front gearbox cover.- Remove all quick-change drill chucks and drill bits from the gearbox. (See section 7-202).- Fix the new quick-change drill chucks and drill bits to the gearbox. (See section 7-202).- See illustration 7-601-01 for placement of the spindles.- Set the drilling depth, if necessary, in accordance with the instructions given in section 7-301. The drillingdepth must be set so that the workpiece can be drilled all the way through. (The position indicator “5” onillustration 4-002-03 should be set at less than 15).- Set the depth gauge in accordance with section 7-302. The adjusting component must be removed sothat the workpiece can be drilled all the way through.- Set the bore hole spacing, if necessary, in accordance with the instructions given in section 7-303.- Set the drilling speed of the vertical bore head, if necessary, in accordance with the instructions given insection 7-304.- Activate the travel limit for the vertical bore head, if necessary, in accordance with the instructions given insection 7-305.- Set the side stops, in accordance with the instructions given in section 7-501, and the stop adjustmentgauge, in accordance with the instructions given in section 7-502.- Adjust the hold-down device, if necessary, in accordance with the instructions given in section 7-504.- Install both machine table inserts, if necessary.- Turn on the main switch again. The Multipress is now ready to operate.Operating the Multipress:- Place the base on the machine table.- Place the front panel on the base, with one hand against the stop pins and press against the side stop.- Clamp the workpiece with the hold-down device. This is available as an accessory if needed.- Press the vertical bore head start button with second hand until the bore head reaches the drilling depthset with the knurled screw “6”. (Illustration 4-002-03).Caution:While the machine is being operated: keep hands clear of the danger area around the hold-down device,the insertion die arm and the gearbox. The safety information given in section 2 is to be followed wheneverthe machine is being operated.The star in your cabinet77