7. operating the multipress - Grass

7. ARBEITEN MIT DER COMBIPRESS7-607 Drilling and inserting fastening hardware Illustrations 7-607-01 and 7-607-02Required Equipment:- 1 drill bit with a 20 mm Ø, right - cup bore hole- 1 drill bit with a 10 mm Ø, left - dowel bore holes- 1 insertion die corresponding to the fastening hardwareMachine Set-Up:- Turn off the machine at the main switch in the switchgear cabinet.- Lift up the front gearbox cover.- Remove all quick-change drill chucks and drill bits from the gearbox. (See section 7-202).- Fix the new quick-change drill chucks and drill bits to the gearbox. (See section 7-202).- See illustration 7-606-01 for placement of the spindles.- Mount insertion dies to suit fastening hardware being installed. (See section 7-203).- Set the drilling depth, if necessary, in accordance with the instructions given in section 7-301 and 7-302using the drilling depth data given in the product specifications.- Set the drilling distances, if necessary, in accordance with the instructions given in section 7-303.- Set the drilling speed of the Multipress, if necessary, in accordance with the instructions given in section7-304.- Deactivate the travel limit for the vertical bore head, if necessary, according to instructions in section 7-305.- Set the side stops, in accordance with the instructions given in section 7-501, with the stop adjustmentgauge, according to the instructions in section 7-502.- Adjust the hold-down device, if necessary, in accordance with the instructions given in section 7-504.- Turn on the main switch again. The Multipress is now ready to operate.Operating the Multipress:- Place the workpiece on the machine table with one hand pressed against the stop pins and side stop.- Clamp the workpiece with the hold-down device. This is available as an accessory if needed.- Press the vertical bore head start button with second hand until the depth gauge terminates the drillingcycle or until the bore head reaches the drilling depth set with the knurled screw “6”. (Illustration 4-002-03)- Place the fastening hardware on the insertion die.- Swing the insertion die arm down to the stop.- Press the vertical start button until the fastening hardware is completely inserted.- Swing the insertion die arm back up to the stop.Caution:While the machine is being operated: keep hands clear of the danger area around the hold-down device,the insertion die arm and the gearbox. The safety information given in section 2 is to be followed wheneverthe machine is being operated.The star in your cabinet75