7. operating the multipress - Grass

7. OPERATING THE MULTIPRESS7-606 Drilling and inserting visible cabinet hinges Illustrations 7-606-01 and 7-606-02Required Equipment:- 1 drill bit with a 35 mm Ø, right - cup bore hole- 2 drill bits with 8 mm Ø, left - dowel bore holes, only for cabinet hinges with pre-mounted dowels- 1 insertion die to suit each type of cabinet hingeMachine Set-Up:- Turn off the machine at the main switch in the switchgear cabinet.- Lift up the front gearbox cover.- Remove all quick-change drill chucks and drill bits from the gearbox. (See section 7-202).- Fix the new quick-change drill chucks and drill bits to the gearbox. (See section 7-202).- See illustration 7-606-01 for placement of the spindles.- Mount insertion dies to suit the cabinet hinges being installed. (See section 7-203).- Set the drilling depth, if necessary, in accordance with the instructions given in section 7-301 and 7-302using the drilling depth data given in the product specifications.- Set the bore hole spacing, if necessary, in accordance with the instructions given in section 7-303.- Set the drilling speed of the Multipress, if necessary, in accordance with the instructions given in section7-304.- Deactivate the travel limit for the vertical bore head, if necessary, in accordance with the instructions givenin section 7-305.- Set the side stops, according to the instructions in section 7-501 and the stop adjustment gaugein accordance with the instructions given in section 7-502.- Adjust the hold-down device, if necessary, in accordance with the instructions given in section 7-504.- Turn on the main switch again. The Multipress is now ready to operate.Operating the Multipress:- Place the workpiece on the machine table with one hand pressed against the stop pins and side stop.- Clamp the workpiece with the hold-down device. This is available as an accessory if needed.- Press the vertical bore head start button with second hand until the depth gauge terminates the drillingcycle is over or until the bore head reaches the drilling depth set with the knurled screw “6”. (Illustration4-002-03)- Place the cabinet hinge on the insertion die.- Swing the insertion die arm down to the stop.- Press the vertical start button until the hinge is completely inserted.- Swing the insertion die arm back up to the stop.Caution:While the machine is being operated: keep hands clear of the danger area around the hold-down device,the insertion die arm and the gearbox. The safety information given in section 2 is to be followed wheneverthe machine is being operated.The star in your cabinet73