7. operating the multipress - Grass

7. OPERATING THE MULTIPRESS7-602 Drilling and inserting the Grass Baseplate Systems 1000, 3000Illustrations 7-602-01 and 7-602-02Required Equipment- 1 drill bit Ø 10 mm, right - dowel bore hole- 1 drill bit Ø 10 mm, left - dowel bore hole- 1 insertion die corresponding to baseplateMachine Set-Up:- Turn off the machine at the main switch in the switchgear cabinet.- Lift up the front gearbox cover.- Remove all quick-change drill chucks and drill bits from the gearbox. (See section 7-202).- Fix the new quick-change drill chucks and drill bits to the gearbox. (See section 7-202).- See illustration 7-602-01 for correct spindle placement.- Mount the insertion dies to suit the baseplates (see section 7-203).- Set the drilling depth, if necessary, in accordance with the instructions given in section 7-301 (or 7-302 ifnecessary) using the drilling depth data given in the product specifications.- Set the drilling distances, if necessary, in accordance with the instructions given in section 7-303.- Set the drilling speed of the Multipress, if necessary, in accordance with the instructions given in section7-304.- Deactivate the travel limit for the vertical bore head, if necessary, in accordance with the instructions givenin section 7-305.- Set the side stops, in accordance with the instructions given in section 7-501 with the stop adjustmentgauge (see section 7-502).- Adjust the hold-down device, if necessary, in accordance with the instructions given in section 7-504.- Turn on the main switch again. The Multipress is now ready to operate.Operating the Multipress:- Place the workpiece on the machine table with one hand pressed against the stop pins and the side stop.- Clamp the workpiece with the hold-down device. This is available as an accessory if needed.- Press the start button with second hand until the depth gauge terminates the drilling cycle or until the borehead reaches the drilling depth set with the knurled screw “6”. (Illustration 4-002-03)- Place the baseplate with the pre-mounted dowels on the insertion die.- Swing the insertion die arm down to the stop.- Press the vertical bore head start button until the cabinet hinge is completely inserted.- Swing the insertion die arm back up to the stop.Caution:While the machine is being operated: keep hands clear of the danger area around the hold-down device, theinsertion die arm and the gearbox.The safety information given in section 2 is to be followed whenever the machine is being operated.The star in your cabinet65