7. operating the multipress - Grass

7. OPERATING THE MULTIPRESS7-1 Requirements for operatorsThis machine should be operated only by trained persons who are thoroughly familiar with the machine andits applications. This knowledge may be obtained by studying the operating instructions thoroughly or byhands-on training by a specialist.The operators must be physically capable of running the machine. It is the responsibility of the owners tomake certain that only qualified persons operate this machine.It is the machine owner’s responsibility to comply with these instructions.7-2 Setting up the Multipress7-201 Installing the drill bit into the Multipress drill chuck Illustrations 7-201-01/02Necessary tools:4 mm Allen key- Loosen the fastening screw “2” with the 4 mm Allen key “1”.- Insert the drill bit “3” up to the stop pin in the drill chuck “5”, being careful of the drill bit’s position “4”.- Tighten the fastening screw “2”.Warning:In order to ensure that the drill bits all bore the same drilling depth, they must be set to the length “x“specified in illustration 7-201-02.7-202 Mounting an insertion die Illustrations 7-202-01, 7-202-02- Swing the insertion die arm up.- Loosen the clamping screw of the insertion die.- Insert the die with the clamping screw first.- Tighten the clamping screw by hand.The star in your cabinet51