7. operating the multipress - Grass

4. DESCRIPTION OF MACHINE COMPONENTS4-002 Description of the individual assembly componentsMachine table Illustration 4-002-011 Machine table that is 1 or 2 meters wide with plastic surfaces2 First stop guide, 720 mm long3 Second stop guide, 770 mm long (accessory)4 Left fence5 Right fence6 Stop pins on guide7 Left side stop8 Right side stop9 Holding fixture for third stop guide, 720 mm long10 Zero-point for stop adjustment gauge in the center of the machine table11 Zero-point for stop adjustment gauge in the center of the gearbox12 Pendulum stop in preparation13 Pneumatic workpiece hold-down device, in preparation14 Revolver stop - movement restriction of the horizontal bore head15 Manual wheel for adjusting the depth of the vertical bore head16 Revolver stop - 6 different drilling depths for the horizontal bore head17 Aluminum profile - lengthwise frame18 Location holes for extension barsItems in numbers 12, 13, 14 and 16 are accessories only and are not included in the standard equipment.Base frame model with horizontal bore head Illustration 4-002-021 Knob for the revolver stop. There are 6 different settings for drill bit lengths.Position “2” on the knob is for the 57 mm long drill bit; position “4” for the 75 mm long drill bit,position “6” for the 100 mm long drill bit; and, positions “1,” “3,” and “5” are for the maximum 140 mmlong drill bit.2 The manual wheel with the reversible handle is used to adjust the vertical boring distance.3 The knob for the revolver stop. The customer has a choice of 6 different drilling depth settings.4 The support bracket for the machine table5 The adjusting screw for setting the height of the machine table6 Aluminum profile - lengthwise frame7 Guide bars for horizontal movement with the vertical and horizontal bore heads8 Feed cylinder for the horizontal bore head9 The support pedestal behind the horizontal bore head10 The support pedestal in front of the horizontal bore head11 The support pedestal behind the vertical bore head12 The support pedestal in front of the vertical bore head13 The revolver stop with setting screws for 6 different drill bit lengths for drilling depths14 The revolver stop with setting screws for 6 different drill bit depths15 An adjustment spindle for the vertical drilling distances16 Mechanical position indicator for the vertical drilling distances17 Coupling component for the horizontal bore headDepending on the model, item numbers 1, 3, 8, 9, 10, 13, 14 and 17 may not be included.The star in your cabinet25