7. operating the multipress - Grass

2. SAFETY INFORMATION2-001 Safety information- It is the responsibility of the machine owner or his/her authorized representative to make certain thatmachine operators are correctly trained in the operation of the machine.- Only licensed electricians or electrical specialists should work on the electrical equipment.- The pneumatic and electrical connection lines should be installed properly and are to be protected fromdamage (by cable ducts or something similar).- The safety devices provided must always be used in accordance with section 2-004, and must not be bypassedor rendered inoperable.- During service or maintenance work, the machine must be disconnected from the electrical system(pull the plug out) and the machine must also be disconnected from the pneumatic compressed air supply(with quick coupling, for example).- Before changing a tool or gear, or before operating in the area of the drill, always set the main switch onthe switchgear cabinet to 0 (off).- Use only tools which meet specifications and regulations and are suitably, strong and durable (availablefrom the Grass product line).- Only tungsten carbide or “high speed steel” drill bits with a total length as specified on page 2 and a shaftdiameter of Ø 10 mm should be used.- The drill bit diameter should only have a maximum of 35 mm on the drive spindle and a maximum ofØ16 mm diameter on all other spindles.- Before operating the machine, all safety devices must be checked to make sure they are intact andfully functional. Damaged parts should be replaced by authorized parts only.- The operator should be especially careful with larger workpieces that project out over the machine.It is advisable to fit a larger support or to use additional supports for the workpiece.- Shavings should not be blown off, but should be vacuumed with the appropriate device.- The machine should always be turned off at the main switch when the work is finished and then securedso that unauthorized persons cannot start it.- Keep the workplace and the surrounding area clean because messy and disorganized workplaces increasethe risk of injury.- Protect yourself from electrical shocks.- The machine should be operated only in dry areas. Never leave the machine outside, especially in the rain.- Keep unauthorized persons away from the machine.- Only one person shall operate the machine at a time.- When working, keep your hands away from the operating area of the drill and the insertion die arm.- Wear appropriate work clothing when operating the machine.- Use a hair net if you have long hair and do not wear wide or floppy pieces of clothing which could becomecaught in moving parts.2-002 Recommended applications- The Grass Multipress is to be used exclusively for drilling solid wood, wood derived materials, and for thepurposes described in section 7-4. The manufacturer is not liable for other uses or applications not specified.The owner and operator of the machine alone assumes all risks.- The operator must comply with the operating instructions when determining appropriate uses.- The machine must be only be operated, serviced, maintained and repaired by authorized trained personnel.- The original set-up may not be modified without the prior express written consent of Grass AG.The star in your cabinet11