Pyronix Conqueror User Guide - Lockmates
Pyronix Conqueror User Guide - Lockmates
Pyronix Conqueror User Guide - Lockmates
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4 ZONES8 TROUBLESHOOTING4.1 Engineer Programmable ZonesEntry / ExitAccessThis is a zone which allows limited-time access to thepremises in order to set or unset the system.This is a zone which, on setting the panel, allows accessto the Entry / Exit zone. However, if the panel is set andan Access zone is triggered before an Entry / Exit zonethen an alarm will be generated immediately.KEY:= LED OFF=LED ON1. Panel set / on=LED FLASHING1CE@@5 !J?>5 "J?>5 #J?>5 $D1=@5B@1 ImmediateThis is a zone which will, when entered create an alarmwhen the panel is set.2. Panel unset / off.OmittedIf a zone is programmed as an Omitted zone by theEngineer, then it is ignored by the panel. Primarily usedfor Part set options. It also allows the user to continue touse the alarm system even if a fault has been discoveredon one or more zones.2CE@@5 !J?>5 "J?>5 #J?>5 $4.2 24 hour zonesPersonalAttackTamperFireTriggering of the Personal Attack (P.A) zone will always be cause afull alarm activation regardless of whether or notthe panel is set.A tamper zone activation will only generate an internalalarm, if the panel is in Day mode. If a tamper fault ispresent and the panel is then set, the system will give asecond internal alarm. Triggering of a tamper zone whenthe panel is set will always give an external as well asinternal alarmTriggering the fire zone will only operate the internalsounder. A fire alarm is identified by a three note risingsound which is easily distinguished from all other tones.Zone 4 may be configured as a fire zone.3. Panel unset . Zone1, Zone 2, Zone 3 ,Zone 4 LEDs on.This shows an alarm has occuredon Zones 1 to 4. Zone 2 wasactivated first. To clear alarm lightsenter <strong>User</strong> code. If the LEDs do notclear call engineer.3D1= @5B@1 **The Fire Zone is intended as an extra feature to the Intruder Alarm system and mustnot be regarded as a total fire protection system**4. Personal attack activated.Enter <strong>User</strong> code to clear P.A light.Reset Personal Attack buttons if necessary.If the LED does not clear call the engineer.4CE@@5 !J?>5 "J?>5 #J?>5 $D1=@5B@1 6RINS 049 issue-111