record of turbine maintenance - Apollo HVLP

APOLLO HVLP TURBINES
Each TrueHVLP Turbine Unit offers the finisher a maximum operating pressure. This pressure is determined
by the size and output of the unit you have selected. The maximum available pressure will have a
direct bearing upon the viscosity of the fluid that you choose to spray. Atomizing pressure and fluid viscosity
directly relate to the efficiency of the equipment operation and the quality of the results that you
will achieve.
The available air volume and pressure at the air cap of the spray gun will meet the delivery of fluid
coming out of the nozzle to create a fine mist called atomization. This mist travels directly to your work
piece where it blends together to form a connected wet film. Achieving a smooth, level surface will
depend on the proper relationship between available atomizing pressure, the viscosity of the coating
being applied and the properties of the coating.
Apollo Turbine Models 725 and 825
Model 725
Model 825
3-Stage Turbine
5.5 psi (0.38 bar)
115 cfm (3.25 cmm)
Dual air filtration
Single gun
110-120 volts, 60Hz, 11 amps, 1.65H.P.
220-240 volts, 50Hz, 5.5 amps, 1.65H.P.
Weight: 29lbs (13.2kg)
Height: 12" (30.48cm)
Width: 8.5" (21.6cm)
Length: 15" (38.1cm)
All EU units shipped
All 110 volt units are
tested and certified.
6
Model 725
Hi Power 2-Stage Turbine
4.5 psi (0.31 bar)
112 cfm (3.17 cmm)
Dual air filtration
Single spray gun
110-120 volts, 60Hz, 10 amps, 1.5H.P.
220-240 volts, 50Hz, 5 amps, 1.5H.P.
Weight: 19lbs (8.6kg)
Height: 11" (27.94cm)
Width: 7.25" (18.41cm)
Length: 11.25" (28.58cm)
All EU units shipped
All 110 volt units are
tested and certified.
Model 825