Controllers - AGCO Parts

CP Nozzles
TUNE-UP TIPS FOR CP FLOATER NOZZLES AND COMBOS
Part # Description
056206 Poly Selector, Regular Volume
055513 Poly Selector, Low Volume, 10 Orifice
057435 Poly Selector, Low Volume, 8 Orifice
056205 Stainless Selector, Reg. Vol.
055512 Stainless Selector, Low Vol., 10 Orifice
057436 Stainless Selector, Low Vol., 8 Orifice
056204 360° Stainless Deflector, Reg. Volume
056885 3-Way Stainless Steel Deflector
055511 360° Stainless Deflector
Low Vol, 10 Orifice
057438 360° Stainless Deflector
Low Vol, 8 Orifice
057240 Floater Nozzle Body
057265 Combo Body
057433 Combo Cap
718219 Teflon Seal
056202 Teflon Seal—E-Version
718225 Combo Teflon Diaphragm
718159 Combo Viton Diaphragm
056207 Stainless Steel E-Ring
718228 #8 O-Ring, Viton
718218 $11 O-Ring, Viton
718227 #13 O-Ring, Viton
718224 Combo Check Valve Spring
057434 Gasket, 3/4" EPDM
718222 Detent Spring, Stainless Steel
718177 Detent Ball, 5/32 nd , 316SS
718220 Stainless Steel Locking Nut
718221 Stainless Steel Washer
Technical Pages
Like all precision equipment, CP Nozzles perform better with good maintenance. It
is recommended that the following be done prior to the beginning of each new
season.
u
u
Holding the nozzle upright, remove nut, deflector and selector. Turn nozzle upside
down catching the detent spring and ball. Blow out detent chamber. Thoroughly
wipe all dust residue from seal, selector and nozzle body.
Fill detent spring chamber with marine bearing grease. Push spring and detent ball
into chamber. Install selector, deflector, washer and nut.
u
Tighten nut so there is heavy drag on the seal.
This maintenance is especially recommended when liquid fertilizer has been used.
Liquid fertilizer can cause the detent to lock if not well lubricated.
cp7/98
Please Note: For a complete AGCO part number; please add AG to the front of the six digit number.
213