Thermal Solutions Boiler Controller To Building Automatio
Thermal Solutions Boiler Controller To Building Automatio
Thermal Solutions Boiler Controller To Building Automatio
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Thermal</strong> <strong>Solutions</strong> ProtoNode Start Up guide Page 6 of 32<br />
2 BACNET/LONWORKS SETUP THROUGH PROTOCESSOR PROTONODE<br />
RER/LER<br />
2.1 Installation steps for the customer<br />
1. Record the information about the unit. (See Section 2.2)<br />
2. Set the BAUD rate to 19200 on the TSBC boiler controllers.<br />
3. Set the Modbus RTU device address on all the TSBC boiler controllers.<br />
4. Set the Modbus RTU Serial settings on the EVNI boiler controllers.<br />
5. If using BACnet MS/TP, set the BACnet MS/TP MAC Address on DIP Switch Bank A. (See section 2.3.2)<br />
6. Set the ProtoNode Node ID/Device Instance of the Field Protocol on DIP Switch Bank A. (See section<br />
2.3.3)<br />
7. Set the ProtoNode BAUD rate of the Field Protocol on DIP Switch Bank B. (See section 2.3.4)<br />
8. Set the ProtoNode Field Protocol on Dip Switch Bank S. (See Section 2.3.5)<br />
9. Enable the ProtoNode “Auto Discovery” mode on Dip Switch Bank S. (See section 2.3.6).<br />
10. Connect the ProtoNode to the Field protocol port and the TSBC’s RS-485 Modbus RTU port to the<br />
ProtoNode’s RS-485 interface. (See Section 3)<br />
11. Power up the ProtoNode RER and LER. It will take about 3 minutes for all the OEM devices to be<br />
discovered, and the configuration file to be built.<br />
12. Once the ProtoNode has finished creating the configuration file, set the “Auto Discovery” Dip Switch to<br />
“Off” to save the configuration settings.<br />
13. If the Field protocol is BACnet/IP or Modbus TCP, refer to Section 4 to run to run the ProtoNode web GUI<br />
utility program to change the IP address. No changes to the configuration file are necessary.<br />
2.2 Record Identification Data<br />
Each ProtoNode has a unique part number located on the underside of the unit. The numbers are as follows:<br />
<br />
<br />
FPC‐N34‐103‐116‐0799 supports TSBC controllers to BACnet MS/TP, or BACnet/IP.<br />
FPC‐N35‐103‐401‐0810 supports TSBC controllers to LonWorks.<br />
This number should be recorded, as it may be required for technical support.<br />
ProtoCessor 1991 Tarob Court Milpitas, California 95035 USA Web: www.protocessor.com<br />
Tel: (408) 964 4444 Fax: (408) 964 4425 <strong>To</strong>ll Free: (800) 317 8319 x141 email: support@protocessor.com
Change language