Quotation Notice - official website of Thane Municipal Corporation

Quotation Notice
Sealed Quotation are invited from reputed contractor for L.P.G. Cremator at
Majiwada Smashanbhoomi for below mentioned work from 25.03.2013 to
01.04.2013 upto 16.00Hrs. in office hours in the office of Executive Engineer
Officer, P.W.Department, Majiwada Manpada Ward Office, 1 st Floor, Thane
Municipal Corporation, Thane – W.
No Item Description Rate Unit Amount
Rs.
1 Cremator Furnace:
Cremator furnace shell consisting of
combustion chamber dully lined with
refractory bricks of high alumina
content of over 40 % AL2O3 and
backed by insulating bricks, with
back up insulation of 25 mm thick
ceramic wool provided inside outer
cover panels and operator view glass
and body loading at 900 mm height
from the ground level. Heavy duty
rolled M.S. sections and good quality
fabrication with hearth provided with
refractory cast slabs. Wielding done
up side down to prevent leakages and
225 mm size taper refractory bricks
are used to provide the crown or arch
weighing about 8.5 tons etc.
complete. Outer dimensions of the
cremator are 3.35 M long, 1.52 M
wide and 1.83 M tall. Inside
dimensions of the cremator are 2.44
M long, 0.99 M wide and 0.60 M tall
necessary N.O.C. & permissions
taken from various department for
L.P.G. cremator installation &
operation.
1
unit
2 Burner:
Gas burner of North American design
suitable for 30 kgs/hr capacity
345000 Kgcal/ Hour for LPG with
Auxiliary burner complete with
refractory burner blocks of 300 mm x
300 mm, atomizing arrangement with
gas and air lines duly connected etc.
complete
3 Blowers:
Blowers with air lining flange welded
construction. Blowers are
interconnected to facilitate supplying
air from either blowers to the burner
in case of emergency. The blowers
2
units
3
units

are fitted 3 phase, 3 HP induction
electric motors and are of 300 CFM
capacity with over load relays and
contactors and separate switches and
fuses etc. complete
4 Reticulation:
Gas reticulation for supplying the LP
Gas to the cremator from the gas
cylinders storage shed with pig tails,
regulators for 48 cylinders, shut off
valves, ‘C” class quality seamless
pipe of 25 mm dia, pressure gauges,
change over valve, solenoid valves,
shut off valves etc. complete
5 Door Assembly:
Door assembly lined like the main
furnace body of the cremator with
1.5” thich asbestos rope as sealent
with male female refractory seal.
Supported on 3 nos Plummer blocks,
with counter weight type
arrangement and chain pulley blocks
for easy operation. Door weighs 0.5
tones etc. complete
6 Body loading mechanism:
Body loading mechanism with 10
guage high carbon steel metal mesh
belt with sprocket and chain
arrangement with a geared reduction
motor and separate traveling Crain
type cable suspended from above for
ease in operation etc. complete
7 Control panel:
Electric control panel with 3 nos of
pilot lamps, 3 MCB’s, 100 amps bus
bar, and one number of temperature
indicator of digital dancing type
characters with contactors and relays
for each motor. Separately in M.S.
fabricated unit dully wired etc.
complete
8 Chimney:
30 Meter self supporting type M.S.
chimney with pilot lamps, lightning
arrestor, dully painted with
temperature resistant (400 Degree C)
900 mm dia at bottom and 300 mm
on top. Each section joined with
flanges etc. complete
1
unit
1
unit
1
unit
1
unit
1
unit

9 Water scrubber:
S.S. 304 ventury type water scrubber
of 1000 mm dia, with 5 mm thick
S.S. 304 partition, necessary ducting
up to the chimney. 6000 litres
capacity water tank with pump and
plumbing etc. complete
10 Generator:
7.5 KVA 3 phase generator duly
coupled with alternator, mechanical
change over, cabling, control panel ,
air cooled 10 hp diesel engine with 4
nos of anti vibratory mounts etc.
complete
11 Fire Fighting:
Fire fighting equipments Dry
Chemical Powder (DCP) 7.5 Kgs
capacity 2 nos and Carbon Di Oxide
(CO2) 2 nos. of fire extinguishers
along with 2 nos. of sand buckets
1
unit
1
1
12 Deposit of LPG cylinder 48
13 LPG cylinder of 19 Kgs each 48
14 Operation of the cremator for first 1
year (12 months) from the date of
commissioning of the cremator.
3 + 1= 4 workers and 1 supervisor
15 TOTAL
Per month
12
months
The sealed Quotation will be opened in the office of Executive
Engineer on 01.04.2013 at 16.30pm in front of Contractor or their
representative if possible.
Executive Engineer
P.W.Department,
Majiwada Manpada Ward Office,
Thane Municipal Corporation, Thane