Installation Manual - Meridian Microwave
Installation Manual - Meridian Microwave
Installation Manual - Meridian Microwave
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
AR/GE/FE/U 80/80X <strong>Installation</strong> <strong>Manual</strong><br />
3.10Auto Calibration<br />
The Auto Calibration feature scans the receive signal across the entire (broad) band and flattens the<br />
levels, much like the equalizer on your home or car stereo.<br />
The radio system is said to be in “Alignment Mode” when it is first powered up with no fiber<br />
connected.<br />
The Auto Calibration mode is triggered ON as soon as the fiber cable is connected. The fiber<br />
interface of the radio terminal needs to detect an optical signal of the appropriate wavelength. This<br />
requires the fiber optic cables be connected to a 1000BaseX port on an Ethernet device (switch,<br />
router, media converter, etc.) or this can be accomplished with a fiber optic loopback cable by<br />
connecting the fiber output of the radio into the fiber input of the radio.<br />
If used, the loopback cable should only be connected long enough for autocalibration to start and<br />
should be removed immediately.<br />
The radio terminal indicates the Auto Calibration by flashing the Link LED on/off this cycle lasts<br />
for up to 120 seconds.<br />
Autocalibration is a required step per installation once antenna alignment is completed.<br />
3.10.1 AdaptRate Fiber Calibration Procedure (AR80 and AR80X only)<br />
In order for an Adaptive Rate link to operate correctly, it is especially critical to ensure the following<br />
process is followed exactly. If you feel this process may not have been followed or you wish to reattempt<br />
the process, be sure to first power down both radios, remove any fiber connection before<br />
turning the system on. This will get you back to original factory radio calibration settings and place<br />
the radio link in “alignment mode”.<br />
START:<br />
1. First, with a local PC, view each radio's Setup page and make sure the operating mode is set<br />
to AR and that the <strong>Installation</strong> Auto Calibration is 'enabled' at both ends. The default value is<br />
‘enabled’.<br />
VERIFICATION: Double check this setting on both radios.<br />
2. On initial Power up, do not connect any fiber cables<br />
VERIFICATION: It is best to physically disconnect any fiber cables from the radio unit ports,<br />
rather than just relying on the far ends of the cables being disconnected.<br />
3. Upon completing the antenna alignment procedure, make sure both ends have a minimum of<br />
2VDC in Quality voltage, if not, further alignment may be required. Small fluctuations are<br />
okay.<br />
26 58000519 rev. D