Installation Manual - Meridian Microwave
Installation Manual - Meridian Microwave
Installation Manual - Meridian Microwave
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
AR/GE/FE/U 80/80X <strong>Installation</strong> <strong>Manual</strong><br />
3.9.6 Locking Down Radio Antenna<br />
24. After the target RSL level has been achieved, ensure all bolts are tightened evenly, securely<br />
and ensure the RSL voltage remains unchanged after tightening is completed.<br />
25. The very narrow beam width of this antenna (0.4º and 0.9º) makes it necessary to completely<br />
tighten the bolts of the azimuth adjustment while adjusting the elevation and vice versa.<br />
26. Always evenly tighten bolts in small fractions at a time to ensure minimum change to your<br />
completed alignment.<br />
3.9.7 Connecting the Fiber<br />
Connect the fiber cable to one of the radios at a time. The fibers should already be connected to<br />
active network equipment.<br />
The fiber integrity indication on the network equipment could<br />
show up or down independent of the RF link status.<br />
3.9.8 Auto Calibration<br />
27. Once the fiber is connected to the radio, the radio will begin an internal link calibration.<br />
28. During this time the Link Up LED will blink for up to 120 seconds.<br />
29. Wait until the Link Up LED is lit solid<br />
30. Verify the Link Quality voltage is 3.03.3V (i.e., error free). Repeat steps (3032) for the farend<br />
radio. For more details on Auto Calibration see section 39 below<br />
3.9.9 Remove the Test Cable<br />
31. Remove the test cable from the radio, replace the rear plastic cover and hand tighten the back<br />
cover nut to the point where the back cover stops (i.e. when it hits the metal ring on the back<br />
metal plate). The installation is now complete.<br />
The most important alignment ‘tool’ for these models is care and<br />
patience! It is recommended that these models be aligned with<br />
personnel present at both ends of the link, and the installers<br />
should allow 90 minutes to optimally align these units.<br />
80 and 80X antennas exhibit narrow beam widths of 0.9º and 0.4º. Link distances are great and<br />
alignment becomes more critical.<br />
25 58000519 rev. D