Installation Manual - Meridian Microwave

More documents

Recommendations

Info

AR/GE/FE/U 80/80X Installation Manual A 48Volt DC version is available for this product. The power connector is the same but the connector location is slightly moved. The NMS ’Status Page’ reading will still read 24V. Figure 3.7.21: 80GHz power and data cables with service loop for strain relief and proper fiber bend radius. 3.7.3 Ground Cabling The preferred method for grounding the radio unit is to ground the mast to a ground source, since this provides the largest grounding surface contact possible. If this is not possible, then use the following procedure: 1. Attach the lug of the ground cable (not provided) with the radio to one of the two #8 holes at the bottom of the radio using a #832 x ½” long bolt, #8 lock washer and #8 flat washers (not provided). 2. Connect other end of the ground cable to a nearby ground location. 3.7.4 10/100BaseT Surge Suppressor If the 10/100BaseT port is permanently connected to other network equipment (not normally required), it should be connected using Cat5e UTP cables rated for the outdoor and/or indoor environments where the cables will be run. It is essential that the cabling be connected to the radio unit through an Ethernetrated surge suppressor inside of the plastic back cover of the unit, and a surge suppressor should also be used at the point where the cable enters a building or is connected to other outdoor equipment that does not already contain surge suppression hardware. 17 58000519 rev. D
AR/GE/FE/U 80/80X Installation Manual For more information on recommended accessory devices and kits, contact BridgeWave Sales Failure to install surge suppression hardware on the UTP cable inside the radio and a second surge suppressor at the building’s pointofentry can expose the radio and network equipment to electrical surges due to lightning strike or other phenomena. Such electrical surges could cause irreparable damage to the radio and/or network equipment not covered by the manufacturer’s warranty. Figure 3.7.41: Ethernet surge suppressor connected to radio 10/100BaseT port 18 58000519 rev. D
Page 1 and 2: Making connections in a highspeed
Page 3 and 4: AR/GE/FE/U 80/80X Installation Manu
Page 5 and 6: Table of Contents AR/GE/FE/U 80/80X
Page 21: AR/GE/FE/U 80/80X Installation Manu
Page 43: AR/GE/FE/U 80/80X Installation Manu

Installation Manual - Meridian Microwave

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?