Installation Manual - Meridian Microwave
Installation Manual - Meridian Microwave
Installation Manual - Meridian Microwave
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
AR/GE/FE/U 80/80X <strong>Installation</strong> <strong>Manual</strong><br />
The radio is sealed at the factory warranty stickers on the inner<br />
(metal) cover of the radio. There is no need to open this cover in<br />
the field. Tampering with these seals will void the warranty.<br />
3.4 <strong>Installation</strong> Tools<br />
The following tools, not provided by BridgeWave, are required for installing the radio and the<br />
antenna:<br />
· Screwdriver, slotted 0.1 inch wide.<br />
· Openend wrench 9/16 inch 2 ea.<br />
· Openend wrench 1/2 inch.<br />
· Ratchet with 6inch extension and 9/16 inch deep socket.<br />
· Wire stripper/cutter/crimp tool (1016 gauge).<br />
· Electrical tape.<br />
· Fish tape for pulling cable.<br />
· Cable tie wraps.<br />
· Handheld DVM (digital voltmeter) with standard banana plug receptacles.<br />
3.5 Antenna Mount <strong>Installation</strong><br />
1. Read these instructions before beginning installation. Caution<br />
should be used. Qualified persons experienced with antenna<br />
assembly and installation are required for installation.<br />
2. BridgeWave Communications Inc. disclaims any responsibility<br />
or liability for damage or injury resulting from incorrect or unsafe<br />
installation practices.<br />
3. The antenna has been formed to a very close tolerance<br />
parabolic shape. Careful handling and assembly is required to<br />
avoid denting the reflector, which would degrade antenna<br />
performance.<br />
When using the left side radio mount position, the antenna ends up<br />
getting rotated by 180 degrees. The drain hole must be open at<br />
the bottom and closed off at the top of the antenna to prevent<br />
water ingress.<br />
· For the 80X, move the bottom drain hole plug to the top<br />
drain hole position.<br />
· For the Standard 80 remove the four Philips head screws<br />
10 58000519 rev. D