PM-7 Operating Manua.. - Voss Associates

General Description
Windows-Based Software
SECONDS”. The results of the two measurements as well as the
shielding factors for each detector, are displayed on the PC's
monitor.
iv. If “Quit” is selected after performing any of the other functions
displayed on the menu, the operator will be presented with the
message: “WARNING: A Save Will Overwrite the Existing
Calibration File for This Portal”. The function key options allow
one of three options:
• Return to Calibration Menu
• Save Calibration
• Quit.
If or “Q” for Quit are pressed without first saving the data, the
message “Calibration Parameters Have NOT Been Saved! Save
Them? (Y/N) will appear”. Pressing > Y, for Yes, will execute a save
to both disk and Portal; > N, for No, will exit to the first sub menu
without a save. After saving the parameters, the operator is given an
opportunity to print a calibration report. A printer must be
connected to LPT1: on the computer before the report can be
printed. If the report is not printed at this time, it can be printed
later, because it is saved as a text file under the name PM7xx.REP
where xx is the portal address (01-15).
b. Utilities
When “Utilities” is selected from the first submenu, a lower-level
submenu is displayed that presents “Poll, Diagnostics, Scaler,
Reboot, Quit” to the operator.
i. The “Poll” routine displays the portal number (address) and
count time as well as the following detector parameters:
background count rates, RDA levels, Status (Normal or Failed),
and program name and version number. The count time,
background count rates, and RDA levels are displayed in real
time, updating every second.
ii. The “Diagnostics” routine presents a submenu with selections
“Annun”, “Switch”, “Range”, “Variance”, and “Quit”.
Thermo Fisher Scientific
Personnel Monitor -7 Techical Guide_5-7_