PM-7 Operating Manua.. - Voss Associates
PM-7 Operating Manua.. - Voss Associates
PM-7 Operating Manua.. - Voss Associates
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 1 Installation and Setup<br />
Overview<br />
Immediately after unpacking the monitor, inspect it for external damage.<br />
CAUTION <strong>PM</strong>-7 scintillators are delicate and must be handled with care to<br />
prevent jarring. Place the scintillator on a padded surface free of objects or<br />
materials that could damage the protective wrapping. A detector should be laid<br />
flat on a large surface. Do not stack or place anything on the detector. ▲<br />
If the <strong>PM</strong>-7 is shipped in a horizontal position:<br />
-<br />
1. Place the monitor in its<br />
intended location and<br />
unpack it.<br />
2. The monitor ramp must<br />
be installed after the<br />
monitor is in position. All<br />
ramp support pieces are<br />
removable and designed to<br />
allow staff to move the<br />
monitor through a<br />
doorway.<br />
3. If these side pieces must be<br />
removed, begin by taking<br />
off the 1/4-20 hardware<br />
which holds the supports<br />
to the bottom of the<br />
monitor.<br />
Figure 1.1. Unpack the monitor and place it<br />
in the intended location<br />
4. This will be two hex bolts<br />
and two carriage bolts with nuts on each side of the monitor.<br />
5. Once the monitor is in position, reinstall the side support pieces. The<br />
ramp will be installed later.<br />
Thermo Fisher Scientific <strong>PM</strong> -7 Manager User’s Guide_ 1-1