PCM-2 Manual.pdf - Voss Associates

Voice Annunciator Test
boards are displayed. If more than one version of the Modular Detector Board
software is in use in the PCM-2, the communications check result for the MDBs
will read "Multiple Versions". If all the software versions are the same, the
software version number will be displayed.
Remote Annunciator Test
If the voice annunciator option is installed this test may be used to verify that the
voice board is functioning properly. This test cycles through every message in
voice board memory. A potentiometer (R14) on the voice board may be used to
adjust volume.
Badge Reader Test
The PCM-2 supports a bank of 4 remote annunciators; an alarm light, a ready
light, a recount light and a horn. If remote annunciators are used, this test
verifies that they are functioning properly.
Access Gate Check
This test waits for an entry from the badge reader and then echos the number
received on the screen. If a badge reader is not installed or if it doesn't seem to
be working properly, the operator must enter a number via the keypad to exit this
test.
Set PCM-2 Clock
Displays the current status (locked or unlocked) of the entrance and exit gates (if
any). Note: This Access Control Gate Check feature has been developed in
support of PCM-2's Access Control Gate Option (PCM2 OPTS &SA).
Edit Colors
Time and date information are included in all reports produced by the PCM-2.
This utility function resets the clock to a time specified by the user.
The Edit Colors utility function permits changes to the display color schemes.
This may be done as a matter of personal preference, or to coordinate the PCM­
2's display with those of other instruments. The use of this screen is selfexplanatory,
however there is one caution relating to its application: if the same
color is ever used for both foreground and background on a single screen, the
8-2
PCM2.MAN/ Rev A/April 1995