PCM-2 Manual.pdf - Voss Associates

Channel Override Parameters
Values for detector parameters may be entered from the override screen as an
alternative to editing individual detectors. Entries made here will be written to all
detectors simultaneously, replacing the existing values. This capability is useful
during initial setup of the instrument, however care must be taken to preserve any
special values required for individual detectors. For explanations of these
parameters, refer to the applicable detector parameter screen documentation.
[HIGH VOLTAGE (VOLTS): 1550
Channel Override Parameters
~Alpha Channels~~~~~~~~~~Beta Channels~~~~~~~~~1
I ~~~~~~~LD Yes
(% MAX): 5
ACTIVE:
THRESHOLD (% MAX):
Yes
45
EFFICIENCY (%): 22.0 EFFICIENCY (%): 22.0
RDA (DPM): 5000 RDA (DPM): 25000
HI FAIL (CPS): 100000 HI FAIL (CPS): 100000
LO FAI L (CPS): 0.00 LO FAIL (CPS): 0.00
WEIGHT FACTOR: 50.0 WEIGHT FACTOR: 10.0
SHIELD FACTOR: 1.00
Instrument Configuration Parameters
~Instrunent Confi gurati on ParameterS===~~~~~~~~~~~~~~~=n
SERIAL NUMBER: 0000 PRINTER TYPE: Epson
COUNT RATE UNITS: CPS USES BEFORE BKG UPDATE: 0
ACTIVITY UNITS: DPM BKG UPDATE AFTER ALARM? No
COUNT MODE: Min Count Time DAY FILE DIRECTORY STORAGE:
10 ENTRY METHOD: Keypad/Aux TRANSACTIONS? No
RWP ENTRY METHOD: None STATUS CHANGES? No
ALARM HOLD (SEC): 1 SOURCE CHECK RESULTS? No
SYSTEM ADDRESS: 2 DISPLAY MIDWAY RESULTS? Yes
SYSTEM BAUD RATE: 9600 HAND SWITCH REQUIRED? Yes
SYSTEM PROTOCOL: uLAN HIP SWITCH REQUIRED? Yes
ANTI-COINCIDENCE: Enabled L.FOOT SWITCH REQUIRED? Yes
RADON COMPENSATION: Disabled R.FOOT SWITCH REQUIRED? Yes
STATUS LOGGING: Disabled SHOULDER SWITCH REQUIRED? No
VOICE DELAY (SEC): 5 ACCESS CONTROL OPTION? No
STORE TRANSACTIONS? No LO LEVEL PASSWORD:
PRINT TRANSACTIONS? No HI LEVEL PASSWORD:
PRINTER INIT:
DAY FILE DIRECTORY: C:\DATA
Serial Number
All reports generated by this PCM-2 are identified with this unit number.
5-14
-----------------------------~.._-~~--.--
PCM2.MAN/ Rev A/April 1995