PCM-2 Manual.pdf - Voss Associates

((
'\
29
C/ttIj
tl)
8--­
§--­
~
0­
~
>-....
>-.... §- (§---~
~
I
b
C".)
>-.... 2 req'd
CO
(0;'0) ,
"Qd@-- ),4= II
8­
se~ notes 8---­
/-----e
With assembly complete as snown and all screws snug
but net tight, place a right angle square against items
012 end 014 Actuators, 074 and 020, Brockets and turn
item 104, Bumper until noted squoreness is achieved.
Then tighter, item 660, Screw to fix actuator to bumper
adjustment.
Tighten item 676, Stop Nut only enouC;h to remove the
jduotor pivot" ploy" CO---.l'lQl tighten to point in which
actuator rotational friction exists.
As fino I assembly step, subsequent to actuator-ta-bumper
o(ij~stment steps above, adju3t the switch position within
its m'Juntirg slots such that the switch just closes with
the actuator against its stop. Tighten mounting
scre'Ns and verify thot the switch opens UpOrl Q.O.1;L~Lgtu
actuator movement. Repeat these steps as necessary to
achieve this sensitive switch adjustment.
RIGHT FOOT SW:TCH ana ACTUATOR
LEfT FOOT SWITCH and ACTUATOR