PCM-2 Manual.pdf - Voss Associates

------ ----------
3, 19" lengths
notes
( PCM-2 Base Weldrne .. l, ref
:: I i
I I
C) :
0,,_1
I I
;;ii'"
I I c' u
I I C"-')
I
I
III .".
FRONT VIEW
Film lake-up roll, see notes\
,------------------------,
'II Foot Detector I
L ~
Film supply
Poly Film routinq
FRONT VIEW enlarged
NOTES'
Apply 3 lengths of item 070, foam tope, equally spoced to item 010, roll core,
providing the minimum spacing noted at each end of roll core. Then, wrap biock
electrical tape around both ends of the foam lope and the roll core
pl"oviding the minimum spacing of the
tape from the roll core ends.
Insert t'rHS expansion plug into one e:ld of item 101, roll core, and tighten the
socket head screw until the plug expands to a secure fit within the roll core.
Verify that the expansion plug and socket screw head ere not protruding from the
end of the roll core.
ROute the Film as shown onto the toke-up roll in order to trop ony contaminated
paticles inside the roll.
Poly Fjllll DjSjH1l1Sel' Assembly, PCM-2, 11534-D320, sheet J of 2.