CrX4 User Manual - LinPlug Virtual Instruments

More documents

Recommendations

Info

Appendix B: Modulation Matrix Sources Two types of modulation source are available: unipolar and bipolar. Unipolar modulation sources increase the modulation destination's value in a single direction (e.g. the ModWheel), while bipolar modulation sources both increment and decrement the modulations destination value (e.g. an LFO). “---“ No modulation source is selected. Note Log Note Lin The note being played with exponential response. The modulation value follows the frequency of theplayed note (bipolar). The note being played with a linear response. The modulation value follows the note number (bipolar). Velocity Aftertouch Pitch Wheel The MIDI note-on velocity information. The harder the key is hit, the higher the modulation value (unipolar). The Aftertouch, also sometimes called Pressure value (either Mono or Poly, whatever your keyboard supports) is used as modulation source. Your MIDI keyboard must support this. If this doesn't work it is likely that your keyboard has no aftertouch (unipolar). The value of the Pitch-Wheel is taken as modulation source, maybe it makes sense to reduce the Pitch Wheel range on the Settings page to 0 when using the Pitch Wheel as modulation source. The Pitch Wheel is bipolar Modulation Wheel The MIDI modulation wheel (MIDI CC 1) (unipolar ). This one is mainly used to control the morphing. Thought it might make sense to use it in the modulation matrix. Breath Controller Foot Controller MIDI CC 2 (unipolar). MIDI CC 4 (unipolar). CrX4 User Manual 64
Expression Contr. LFO 1 LFO 2 LFO 3 LFO 4 MIDI CC 11 (unipolar). LFO 1 (bipolar). LFO 2 (bipolar). LFO 3 (bipolar). LFO 4 (bipolar). GenEnvelope 1, 2 The envelope of Generator 1, 2. Generator envelopes control the respective Generator, however if the Generator is not used, or it makes sense within the preset to do so, the envelope can be used as a modulation source (unipolar). ModEnvelope The ModEnvelope is an envelope that has no fixed destination and can be routed to any available modulation destination via the Matrix (unipolar). Fil1, 2Envelope The envelope of the Filters. These envelopes control the respective Filter Cutoff, however if it makes sense within the preset to do so, the envelope can be used as a modulation source (unipolar). Amp Envelope The Main Amplitude envelope. This envelope controls the overall output Volume, however it can be used as a modulation source as well (unipolar). Glide Curve Arpeggiator Alternate Constant The Glide or portamento envelope is used as a modulation source (unipolar). The Arpeggiator. The Alternate modulation source changes between values of 1 and -1 for each note. This is useful for modulation effects such as auto-panning (bipolar). The Modulation Amount is used as a constant modulation value (unipolar). CrX4 User Manual 65
Page 1 and 2:
CrX4 User Manual Copyright LinPlug
Page 3 and 4:
Welcome Thank you for purchasing a
Page 5 and 6:
Ping Pong (Delay)..................
Page 7 and 8:
Common to Mac and PC The first time
Page 9 and 10:
output of filter 1 is send to filte
Page 11 and 12:
User Interface Sections The user in
Page 13 and 14: The Generator Controls The upper an
Page 15 and 16: Time Sampler Generator The Time Sam
Page 17 and 18: Wavetable Generator The CrX4's Wave
Page 19 and 20: which is looped. These three parame
Page 21 and 22: dynamically to MIDI input. If you o
Page 23 and 24: Oscillator Generator The Oscillator
Page 25 and 26: Filters The CrX4 contains two indep
Page 27 and 28: The Filter Envelope section is loca
Page 29 and 30: Velocity to Main Volume The Velo (V
Page 31 and 32: Effects The CrX4 has 6 independent,
Page 33 and 34: St (Stereo) Delay The Stereo delay
Page 35 and 36: Chorus The Chorus effect can be use
Page 37 and 38: Filter The Drive slider (Saturation
Page 39 and 40: Flanger The CrX4’s Flanger can be
Page 41 and 42: Stereo Enhancer The CrX4’s Stereo
Page 43 and 44: The Divider Mode popup menu determi
Page 45 and 46: The Envelopes are positioned in eac
Page 47 and 48: LFO The CrX4’s LFO (“Low Freque
Page 49 and 50: Modulation Matrix The CrX4's Modula
Page 51 and 52: § Random: In this mode the notes o
Page 53 and 54: Preset Browser The Preset Browser s
Page 55 and 56: To use the CrX4’s ECS feature, pr
Page 57 and 58: Library Location / Startup Patch Wh
Page 59 and 60: The “Allow Host Program Change”
Page 61 and 62: LFO: An LFO or Low Frequency Oscill
Page 63: Appendix A: Tempo Sync Settings Tem
Page 67 and 68: Note: The Filters 1 and 2 offer the
Page 69 and 70: Appendix D: Using TUN files in the
show all

CrX4 User Manual - LinPlug Virtual Instruments

Create successful ePaper yourself

Delete template?

Save as template?