CrX4 User Manual - LinPlug Virtual Instruments

Ping Pong (Delay)
The Ping Pong Delay lets the signal move from left to right and back, a bit
like a game of ping pong
The Ping Pong (Delay)
functions as follows: the input
signal is first delayed by Time
Cen amount, then it’s
delayed by Time Left amount
and finally by the Time Right
amount.
When Feedback is applied
the “Time Right” signal is fed
back into the left delay line, so that an alternating left-right delay is
produced.
The Time Cen, Time Left and Time Right sliders are used for setting the
centre, left and right channel delay times (in milliseconds). This can range
from 1 ms to 1300 ms (time display also functions as a Sync menu).
The Feedback slider allows you to set the number of times the signal
repeats or echoes.
The Bal Cen/LR slider is used to set the balance between the initial centre
delay and the following left and right delays.
The Pan Left/Pan Right sliders are used to set the pan position of the left
and right delays.
Hint: If you want the delayed signal to appear on the right side first, use the
Pan controls to exchange left and right positions.
CrX4 User Manual 34