CrX4 User Manual - LinPlug Virtual Instruments

Oscillator Generator
The Oscillator Generator is a not-sample-based source of sounds which
allows a blend between sawtooth and pulse waveform with a number of
options.
The Waveform dial sets the
Generator's waveform shape.
When turned all the way to the
right it outputs a pulse wave.
When turned all the way to the
left it outputs a sawtooth wave.
In intermediate positions it
outputs a waveform that is a
combination of the two.
The Symmetry dial affects the
waveform's shape, expanding and contracting the first half of the cycle, as
in the case of pulse width modulation. Symmetry can be applied to any
available waveform-mix, not just pulse.
The FreeRun button is used for setting the starting point in the waveform’s
cycle when a new note is started. When the FreeRun button is switched off,
the waveform always begins from the same starting point: the begin of the
cycle. When the FreeRun button is switched on, the Oscillator runs
continuously (free or not-retriggered), so that the phase of the waveform at
note start is at a random point is the cycle.
CrX4 User Manual 23