CronoX 2 User Guide 1.02.sdw - LinPlug Virtual Instruments

Glide
The Glide or "portamento" section allows you to set the CronoX's portamento
parameters. "Glide" continuously changes the pitch from one note to the next,
connecting the notes and letting you smoothly "glide" from one to the other.
The Glide section has four controls: the Glide button, the Bend display, the
Time/Rate buttons and the Range control.
The Glide button has 4 values: On, Off, Held and Bend. The On and Off functions
turn "Glide" on and off. When "Glide" is on, the Range dial is used to set the
length of time it takes for the first note to reach that of the second note. Range:
0.001 seconds...1.200 seconds.
The "Held" setting works as follows. If notes overlap then Glide is applied,
however if they don't then the notes are played without Glide. This makes it
possible to apply Glide only to selected notes. "Bend" allows you to apply a
predetermined pitch bend to each note. The bend range is set using the Range
control. A bend range of -48 to +48 semitones is available.
The Time/Rate buttons enable you to choose between two settings: Time and
Rate. These settings determine the manner in which the pitch of one note moves
to that of the next note. When set to "Time", it takes a constant amount of time to
move from one note to the next.
LinPlug CronoX User Guide 1.02 38