CronoX 2 User Guide 1.02.sdw - LinPlug Virtual Instruments

Stereo Delay
The Stereo Delay features controls for: Wet, L Time, R Time, Feed (Feedback),
LP Filter (Cutoff), HP Filter (Cutoff), Left Channel Sync and Right Channel Sync.
The Wet dial allows you to set the balance between the processed "wet" signal
and the original unprocessed "dry" signal. Range: 0%...100%.
The L Time and R Time sliders are used for setting the left and right channel
delay times (in milliseconds). Range: 1 ms...1300 ms.
The "Feed" (Feedback) slider allows you to set the number of times the signal
repeats or "echoes". Range: 0%...99%.
The "LP Filter" (Low Pass Filter Cutoff Frequency) dial is used to set the
frequency (in Hz) above which frequencies are filtered out of the signal. Higher
settings produce brighter sounds while lower settings result in darker sounds.
Range: 40 Hz...22 kHz.
The "HP Filter" (High Pass Filter Cutoff Frequency) dial is used to set the
frequency (in Hz) below which frequencies are filtered out of the signal. Higher
settings produce thinner, brighter sounds, while lower settings produce fatter,
darker sounds. Range: 8 Hz...22 kHz.
The left and right channels of the delay's output can be independently synced to
the song's current tempo using the Sync menus located beneath the L Time and
R Time dials (see Appendix C for the range of possible sync settings).
LinPlug CronoX User Guide 1.02 36