CronoX 2 User Guide 1.02.sdw - LinPlug Virtual Instruments
CronoX 2 User Guide 1.02.sdw - LinPlug Virtual Instruments
CronoX 2 User Guide 1.02.sdw - LinPlug Virtual Instruments
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Filter<br />
The Filter features controls for: Filter Type, Cut (Cutoff), Res (Resonance), Depth<br />
(Cutoff-Mod Depth) and Speed (Cutoff-Mod Speed).<br />
The Wet dial allows you to set the balance between the processed "wet" signal<br />
and the original unprocessed "dry" signal. Range: 0%...100%.<br />
The Filter Type buttons allow you to select one of four filter types: LP (Low Pass),<br />
HP (High Pass), BP (Band Pass) and N (Notch).<br />
The Cut (cutoff) slider is used to set the frequency (in Hz) above which<br />
frequencies are filtered out of the signal. Higher settings produce brighter sounds<br />
while lower settings result in darker sounds. Range 40 Hz...20 kHz.<br />
The Res (Resonance) slider is used to set the amount of emphasis around the<br />
cutoff frequency. Higher settings create a more pronounced peak in the signal<br />
while lower settings produce a flatter response. Range: 0%...100%.<br />
The filter's cutoff frequency can be controlled using the Depth (Cutoff-Mod Depth)<br />
and Speed (Cutoff-Mod Speed) controls. The Depth (Cutoff-Mod Depth) control<br />
is used to set the depth to which the filter's cutoff frequency is modulated. A<br />
setting of 0% means no modulation occurs. The Speed (Cutoff-Mod Speed) dial<br />
allows you to set the rate (in Hz) at which the filter's cutoff frequency is<br />
modulated. Range: Depth (Cutoff-Mod Depth) 0%...100%, Speed (Cutoff-Mod<br />
Speed) 0.04 Hz...4.00 Hz.<br />
<strong>LinPlug</strong> <strong>CronoX</strong> <strong>User</strong> <strong>Guide</strong> 1.02 34