CronoX 2 User Guide 1.02.sdw - LinPlug Virtual Instruments

More documents

Recommendations

Info

The Fade slider is used to set the rate at which the amplifier moves from the Sustain frequency to either 0 (for negative Fade values) or full range (for positive Fade values). A Fade setting of 0 means that the amplifier remains at the Sustain level until the key is released. Range: -10...10. The Release slider is used to set the length of time (in seconds) that the amplifier takes to move from the current level to 0 after the key is released. Range: 0.004 seconds...10 seconds. LinPlug CronoX User Guide 1.02 22
Modulation One of the key features of the CronoX is its sophisticated modulation capabilities. The instrument contains a Modulation Envelope, two independent LFOs (low frequency oscillators) as well as an 8x8 Modulation Matrix that is used to control modulation routing. The Modulation Envelope, LFOs and Modulation Matrix are described in more detail below. LinPlug CronoX User Guide 1.02 23
Page 1 and 2: Copyright: LinPlug Virtual Instrume
Page 3 and 4: Welcome Thank you for buying the "C
Page 5 and 6: GET THE FULL VERSION...............
Page 7 and 8: Mac Installation The CronoX comes w
Page 9 and 10: Overview The CronoX is a 24 note-po
Page 11 and 12: Generators The CronoX's Generator s
Page 13 and 14: TimeSamp Generator The TimeSamp Gen
Page 15 and 16: Schrader Generator The CronoX's "Sc
Page 17 and 18: Source The Source section of the Cr
Page 19 and 20: Filter The CronoX's filter has been
Page 21: Amplifier The CronoX's Amplifier se
Page 25 and 26: The Fade slider is used to set the
Page 27 and 28: The Attack dial setting determines
Page 29 and 30: The three buttons at the top of the
Page 31 and 32: Delay The Delay effect can be used
Page 33 and 34: Phaser The CronoX Phaser can be use
Page 35 and 36: Reverb The Reverb effect is used to
Page 37 and 38: Preset The CronoX's Preset section
Page 39 and 40: In this case it will take the same
Page 41 and 42: Keyboard The CronoX's Keyboard enab
Page 43 and 44: Master Tune is used to set the over
Page 45 and 46: Optimizing CPU Usage Software synth
Page 47 and 48: LFO: Microtuning: Modulation Matrix
Page 49 and 50: Appendix A: Using TUN Files By Jack
Page 51 and 52: 5. Type "set synth" in the command-
Page 53 and 54: Appendix B: Modulation Sources and
Page 55 and 56: Time Samp 2 Cutoff Resonance Pulsew
Page 57: Appendix C: Delay Sync Settings Off

CronoX 2 User Guide 1.02.sdw - LinPlug Virtual Instruments

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?