CronoX 2 User Guide 1.02.sdw - LinPlug Virtual Instruments

Amplifier
The CronoX's Amplifier section... The Amplifier section is located on the right of
the front panel beneath the Glide section.
The synthesizer's main volume level is set using the Vol slider. It has a range of
-oo to 0 dB.
The CronoX's amplifier is also controlled via an ADSFR envelope which consists
of controls for Attack, Decay, Sustain, Fade and Release.
The Attack slider setting determines the length of time (in seconds) it takes for
the amplifier to reach the full envelope depth. For example, if the Attack slider is
set to 0.100 seconds, the amplifier will move from zero to full volume within 100
milliseconds. Range: 0.001 seconds...10 seconds.
The Decay slider setting determines the length of time (in seconds) that the
amplifier takes to move from the Attack peak frequency to the Sustain frequency.
Range: 0.001 seconds...10 seconds.
The Sustain slider setting determines the amplifier after the initial Attack/Decay
phase has been completed. Range: 0.000...1.000.
LinPlug CronoX User Guide 1.02 21