Daniels Tools Catalogs - Interstate Connecting Components

Mid-Current Range Adjustable Indent Crimp Tools
For power supply and power management
applications, DMC offers our
Industrial Mid-Current Range Adjustable
Crimp Tools which have virtually limitless
applications within the specified wire
range of 6 through 18 AWG. The tools
are used widely in the marine, rail, power
generation, solar, and heavy transportation
industries.
The Mid-Current Range Adjustable
Crimp Tools are similar to our Standard
Adjustable indent Crimp Tool but have an
enlarged crimp cavity to accommodate
mid-current power contacts. Turret heads
and positioners are available to adapt
the tool frames to your specific contact/
wire combination. The 8 impression
crimp assures absolute maximum tensile
strength with almost every closed barrel
contact. Special indent configurations are
available upon request.
For proper operation, the tool must be
mated with a multi-position turret head
(or a single-position positioner. These are
attached by orienting the positioner in the
keyed position and by tightening the hex
socket screws provided as part of the
positioner.
A permanent dataplate is affixed to all
turret heads and positioners. This plate
lists specific contact part numbers, the
corresponding position color code (for
3 position turret heads), and suggested
selector depth settings for the wire size
being used.
On most models, crimp depth is controlled
by a position selector knob located
on the tool frame. The operator simply
dials the desired step for the wire being
used. This setting can be secured by use
of a locking pin or safety wire.
As with our Military Standard crimp
tools, the cycle controlled ratchet assures
a complete crimp every time. The carefully
engineered design achieves the absolute
maximum mechanical advantage.
Periodic gaging is recommended to
insure accurate calibration. This can be
done easily by setting the tool selector knob
to the designated position and checking
indenter closure with the “GO/NO-GO”
gage designated for each tool.
These tools measure 9 3 ⁄ 4" x 2 1 ⁄2" x 1 1 ⁄4"
approximately and weighs less than a
pound.
NOTE: Crimping wires and contacts in
this range requires increased hand force
in comparison with other common hand
crimpers, therefore use of this hand tool
should be limited to short run production
and maintenance applications.
Powered versions of these tools are
available for production and repetitive use
(see page 13).
The M320 is designed for Siemens
Industrial Automation contacts, 6FX2003
Series. The M320 crimps both the
conductor and the insulation. This tool
is not available in a pneumatic version.
POSITIONER
P/N
TH579-1
TH580-1
TH581-1
M320 applications
CONTACT MFG. &
PART NUMBER
Siemens Industrial Automation
6FX2003-5AA00 (Conductor) Siemens
Industrial Automation 6FX2003-5AB00
(Insulation)
Siemens Industrial Automation
6FX2003-5AC00 (12 & 16 Conductor,
Insulation)
Siemens Industrial Automation
6FX2003-5AD00 (Conductor, Insulation)
PAGE 92 www.DMCTools.com © Copyright 2010 Daniels Manufacturing Corp. ALL RIGHTS RESERVED.