Daniels Tools Catalogs - Interstate Connecting Components
Daniels Tools Catalogs - Interstate Connecting Components
Daniels Tools Catalogs - Interstate Connecting Components
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Pneumatic Auto-Lift Indent Crimp Termination System<br />
Step 1<br />
Place an uncrimped<br />
contact with wire into<br />
the positioner insert.<br />
When the contact is<br />
loaded into the tool, the<br />
wire barrel remains above<br />
the tool in clear view.<br />
Save Time and<br />
Avoid Errors<br />
DMC’s standard WA-series pneumatic<br />
crimp tools are now available with an<br />
automatic actuator that eliminates the<br />
step of pressing a trigger or stepping on<br />
a foot pedal to actuate the tool.<br />
Additionally, when the contact is<br />
loaded into the tool, the wire barrel<br />
remains in clear view. This allows the<br />
operator to see that the wire is inserted into the contact<br />
(wire barrel) correctly, with all strands inside the contact.<br />
Positioner<br />
Module<br />
Once the wire is properly inserted into the contact, a little<br />
additional pressure on the wire pushes the contact into the<br />
automatic positioner. When the contact reaches the correct crimp<br />
position, the tool automatically crimps the contact on to the wire.<br />
This line of tools available for the semi-automatic crimping of<br />
contact/wire assemblies for wire sizes 12 -32 AWG. However,<br />
Smaller wire sizes (24-32) are not very rigid and some difficulty<br />
may be experienced when pushing down on the contact/wire<br />
assembly. AP systems are not recommended for wire sizes<br />
smaller than 26 AWG.<br />
Step 2<br />
The operator can<br />
then insert the wire into<br />
the contact (wire barrel)<br />
and see that the wire is<br />
inserted correctly, with all<br />
strands inside the contact.<br />
Step 3<br />
Push down lightly with<br />
the wire in one continuous<br />
motion. When the contact<br />
reaches the correct crimp<br />
position, the automatic<br />
positioner will crimp the<br />
contact to the wire.<br />
NO foot pedal or manual<br />
activation required!<br />
Complete<br />
Remove the finished<br />
assembly and insert<br />
the next contact to be<br />
crimped.<br />
Retro-Fit Existing <strong>Tools</strong><br />
If you already have one or more DMC indent crimp<br />
pneumatic tools in your shop, DMC offers a retro-fit kit<br />
(P/N - APMOD ) to upgrade the standard pneumatic tools<br />
to an Auto-Lift pneumatic tool. Conversion also requires the<br />
appropriate QA series positioner modules.<br />
PAGE 14<br />
www.DMC<strong>Tools</strong>.com © Copyright 2012 <strong>Daniels</strong> Manufacturing Corp. ALL RIGHTS RESERVED.