Daniels Tools Catalogs - Interstate Connecting Components
Daniels Tools Catalogs - Interstate Connecting Components
Daniels Tools Catalogs - Interstate Connecting Components
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Electric Hydraulic 3.5 Ton<br />
Crimp Tool for HD36 Dies<br />
A Totally Self-Contained Portable Crimp System for production<br />
The EHCD36 is a fast cycling benchtop<br />
crimp tool designed to be lightweight<br />
and rugged. The versatile features of the<br />
EHCD36 make this a good choice where<br />
production and quality cannot be compromised.<br />
This unit is small in overall size (10.0" H<br />
x 7.1" W x 19.1" L) and weighs approximately<br />
27 pounds, but has ample die<br />
force power to do most jobs. The crimp<br />
cycle time is only two seconds.<br />
Powered by 110VAC with standard<br />
power cord. Other power & cord setups<br />
available.<br />
Compatibility with<br />
Existing Crimp Dies<br />
The EHCD36 is designed to accept<br />
the entire family of D36 dies for crimping<br />
terminals, lugs or any other special applications.<br />
WIRE RANGE: #8 to #0 AWG*<br />
in many power applications, and .750<br />
(19.05mm) in coaxial hexagonal crimping.<br />
This affords total utilization of existing dies<br />
and total interchangeability with HD36<br />
hand tool frame and HDE36B battery<br />
powered hydraulic crimp tool.<br />
Full Cycle Control<br />
Full die closure is assured on every<br />
crimp. The internal cycle control network<br />
will not allow the tool to open until complete<br />
closure is attained. The cycle control<br />
can be overridden with the Emergency<br />
Stop button.<br />
Operator Safety Features<br />
An Emergency Stop button is located<br />
on top of the tool. Depressing this button<br />
releases the hydraulic pressure and allows<br />
the crimp dies to re-open.<br />
A Foot Pedal is Available (P/N EHCFP)<br />
When the foot pedal is plugged to the<br />
unit, it disables the front panel actuator.<br />
Die Selection: The HD36 crimper will<br />
accommodate all crimp dies listed on<br />
page 109. Other applications may be covered<br />
by this tool. Consult DMC for details.<br />
*Wire range will vary depending on wire<br />
and terminal/contact.<br />
© Copyright 2012 <strong>Daniels</strong> Manufacturing Corp. ALL RIGHTS RESERVED. www.DMC<strong>Tools</strong>.com PAGE 111