Daniels Tools Catalogs - Interstate Connecting Components

Special Application Indent Crimp Tooling
BIASED CRIMP TOOLS
(MODELS SC8 & MH993)
Our Biased Crimp tools have a 4 indent
pattern with the flat-tipped indenters that
are offset at an angle of 45 degrees to
produce a radial or spiral pattern around
the application, typically a seamed or
formed barrel contacts. This indent
pattern is also useful for holding springs
(or spring like devices) to a tube or solid
rod. We offer two Biased Crimp tools, the
SC8 for sizes 12 thru 26 AWG and the
MH993 for 20 thru 32 AWG.
SC8
sc8 BIASED CRIMP TOOL
DMC P/N DESCRIPTION PURPOSE
The model SC8 has single flat-tipped
indenters and accommodates wire sizes
12 thru 26 AWG. It accommodates the
TP series positioners. It is 9 3 ⁄4" in length
and weighs approximately 15 oz. Gaging
is accomplished with the G125 “GO/
NO-GO” gage.
The pneumatic power version of this
tool is the WA27AJ.
TP1189 POSITIONER CONXALL 680-SG (SC8)
TP1190 POSITIONER CONXALL 586-SG (SC8)
TP1191 POSITIONER CONXALL 5053-20 GS (SC8)
TP1621 POSITIONER CONXALL 587-PGN5 & 586-SUN
G125 GAGE Go-No Go Test for SC8
MH993
The model MH993 has double tipped
indenters and accommodates wire sizes
20 thru 32 AWG (the miniature to sub-
miniature range). It accommodates the
K series positioners. It is 6 3 ⁄4" in length
and weighs approximately 10 oz. Gaging
is accomplished with the G125 “GO/
NO-GO” gage.
The pneumatic power version of this
tool is the WA22BC.
MH993 BIASED CRIMP TOOL
DMC P/N DESCRIPTION PURPOSE
K484 POSITIONER 65-275-1 (26-30), 65-275-2 (20-24)
K1287S POSITIONER 610-110-101 Virginia Panel
K1732 POSITIONER 587-PGN5 Conxall
K1749 POSITIONER 587-PGN Conxall
G125 GAGE Go-No Go Test for MH993
PAGE 100
www.DMCTools.com © Copyright 2012 Daniels Manufacturing Corp. ALL RIGHTS RESERVED.