0.080mwcff30 - Petrick-GmbH
0.080mwcff30 - Petrick-GmbH 0.080mwcff30 - Petrick-GmbH
- Page 2 and 3: 0.080 MWCFF30 X-ray tube assembly "
- Page 4 and 5: Petrick 0.080 MWCFF30 X-ray tube as
- Page 6: 55 50 °C 45 40 35 Petrick 0.080 MW
0.080 MWCFF30<br />
X-ray tube assembly "Vari-Aqua"<br />
with water-cooling and Be-window tube<br />
Technical data<br />
<strong>Petrick</strong><br />
1. Geometry: according assembly drawing<br />
2. Type of operating: DC<br />
3. Max. operating voltage: max. 50 kV (but just max. approvable voltage of tube)<br />
4. Long-term capacity rating: depending on type of tube<br />
5. Max. housing temperature: 55°C<br />
6. Leakage radiation: < 2,0 µSv/h at 50mm (50kV, 1000µA)<br />
7. Weight: 3.000 g<br />
Emitter housing:<br />
<strong>GmbH</strong><br />
The X-ray tube assembly made of brass is used as protection housing for small fixed-anode X-ray<br />
tubes from <strong>Petrick</strong> <strong>GmbH</strong> and is completely free of lead-parts.<br />
To avoid overheating of the emitter, a temperature limiter is integrated, which is daisy-chained to the<br />
cathode heating, and it is equipped with a water cooling system.<br />
When achieving max. housing temperature, the temperature limiter turns off the heating of the tube.<br />
Applied insulating materials allow an anode voltage of up to 50 kV DC.<br />
A diaphragm system for compensation of oil extension protects the emitter against flashovers in any<br />
position, because no air bubble is located inside.<br />
Applied insulating oil is specially prepared und filled in under vacuum.<br />
Applicable X-ray tubes:<br />
Tubes with various focal spots, different anode materials.<br />
Tube heating:<br />
Tube heating is connected by a 4-pole female connector.<br />
If tube shall work with grid control, the joint between black and brown wire of the provided heatingcable<br />
has to be ripped and the necessary grid voltage to be supplied between black (-) and brown (+)<br />
wire. The tube never has to be operated with open grid connection.<br />
Heating data depend on the applied type of tube.<br />
High voltage connection:<br />
High voltage connection results from a high voltage-cable with UHF-plug 5/8-24 UNEF.<br />
Necessarily the connection has to be protected against impurity and humidity by the protection cap,<br />
which is included in delivery. High voltage-cable has to be cleaned if necessary and the dry surface to<br />
be fine coated with Silicone Paste P4 (available from us) before installation.<br />
HV-cables and heating-cables in customized length as well as hose-connection elements for watercooling<br />
are optional available.<br />
Page 2 from 6
<strong>Petrick</strong><br />
0.080 MWCFF30<br />
X-ray tube assembly "Vari-Aqua"<br />
with water-cooling and Be-window tube<br />
Circuit diagram<br />
Bulkhead recept. jack<br />
Grid voltage (black)<br />
Heating voltage (brown)<br />
Heating voltage (grey)<br />
When working with grid control,<br />
rip here and supply grid<br />
voltage separately.<br />
-<br />
+<br />
- + + -<br />
<strong>GmbH</strong><br />
Heating connection DC<br />
(brown and grey) HV-connection DC<br />
Generator<br />
X-ray tube assembly<br />
Page 3 from 6
<strong>Petrick</strong><br />
0.080 MWCFF30<br />
X-ray tube assembly "Vari-Aqua"<br />
with water-cooling and Be-window tube<br />
Fitting dimensions<br />
M 4 thread depht 6 mm<br />
0-ring flute<br />
53,5 x 60,6 x 2,0<br />
109,0<br />
Detail A, M1:1<br />
ø 47,37<br />
Ø 69,5<br />
Ø 69,0<br />
Ø 18,0 G7<br />
2,8<br />
6,3<br />
187,0<br />
Grid control - (black)<br />
Connection water-cooling:<br />
RECTUS Art.Nr.21KBAW10MPN<br />
Hose connection:<br />
RECTUS Art.Nr.21SBKO06MPN<br />
Filament - (brown) Filament + (grey)<br />
Ground<br />
HV-connection DC<br />
5/8 - 24 UNEF<br />
76,0<br />
<strong>GmbH</strong><br />
41,3<br />
Do NEVER release<br />
the lock screw<br />
33,1<br />
Ø 63,5<br />
30,0°<br />
6,3<br />
2,8<br />
M 1 : 2<br />
Detail A<br />
Ø 18,0 G7<br />
Page 4 from 6
<strong>Petrick</strong><br />
0.080 MWCFF30<br />
X-ray tube assembly "Vari-Aqua"<br />
with water-cooling and Be-window tube<br />
Radiation protection<br />
Brass<br />
Plastic<br />
Brass<br />
Brass<br />
-X-ray tube assembly can emit harmful X-rays<br />
-There is a danger of implosion<br />
-User is account for personal protection by a housing<br />
10 10<br />
8<br />
braun<br />
12<br />
C 1<br />
B 80<br />
schwarz<br />
weiss<br />
10 10<br />
5 5<br />
<strong>GmbH</strong><br />
Stainless steel<br />
Rubber<br />
Plastic<br />
Oil<br />
Copper<br />
Nickel<br />
FeNiCo<br />
Brass<br />
Monel<br />
Beryllium<br />
( * )<br />
Nickel<br />
Tungsten<br />
Glass<br />
Molybdenum<br />
( * ):<br />
Tungsten<br />
Molybdenum<br />
Tantalum<br />
Copper<br />
Chrome<br />
Rhodium<br />
Cobalt<br />
Copper<br />
Brass<br />
Stainless steel<br />
Page 5 from 6
55<br />
50<br />
°C 45<br />
40<br />
35<br />
<strong>Petrick</strong><br />
0.080 MWCFF30<br />
X-ray tube assembly "Vari-Aqua"<br />
with water-cooling and Be-window tube<br />
Temperature-curve<br />
°C<br />
60<br />
55<br />
50<br />
45<br />
40<br />
35<br />
30<br />
25<br />
20<br />
15<br />
10<br />
Characteristic at 23°C ambient temperature<br />
0,50 0,10 0,05<br />
l/min<br />
Housing temperature at 180 W<br />
50 W<br />
1,8<br />
1,6<br />
1,4<br />
1,2<br />
l/min 1<br />
0,8<br />
0,6<br />
0,4<br />
0,2<br />
Pressure-flow-diagram<br />
<strong>GmbH</strong><br />
0 30 60 90 120 150 180 210 240<br />
min<br />
0 0,5 1,0 1,5 2,0<br />
bar<br />
2,5 3,0 3,5 4,0<br />
Page 6 from 6