SmartJoist Design Guide 2011.pub - Tilling Timber
SmartJoist Design Guide 2011.pub - Tilling Timber
SmartJoist Design Guide 2011.pub - Tilling Timber
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
TYPICAL <strong>SmartJoist</strong> FLOOR CONSTRUCTION DETAILS (Cont’d)<br />
Backer for cladding<br />
attachment.<br />
F6<br />
Use double<br />
joists under<br />
wall where<br />
vertical load<br />
exceeds<br />
29 KN/m<br />
<br />
WARNING - CORRECT BLOCKING<br />
FOR <strong>SmartJoist</strong>s<br />
GREEN TIMBER SHALL NOT BE USED<br />
UNDER ANY CIRCUMSTANCE.<br />
All blocking shall be carried out as per details F1-F3, with<br />
blocking to extend to both flanges and skew nailed with<br />
3.15 Ф x 65 nails, one each side of top and bottom flange.<br />
<strong>SmartJoist</strong> shall be designed<br />
to support load bearing wall<br />
above when not stacked over<br />
wall below.<br />
INTERIOR LOAD BEARING AND BRACING WALLS<br />
Load bearing wall<br />
above must stack<br />
over wall below<br />
2 mm<br />
<strong>SmartJoist</strong><br />
blocking<br />
Panel<br />
F7<br />
F8<br />
NOTE: Detail F7 with blocking panel is required for bracing walls.<br />
90 X 45 F5<br />
Cripple skew<br />
nailed to both<br />
flanges with<br />
3.15 x 65 nails.<br />
NON LOAD-BEARING CANTILEVER DETAILS (BALCONIES)<br />
Example cantilever spans and minimum back spans for this detail are shown in the table on the next page<br />
<strong>SmartJoist</strong> blocking<br />
Non Load bearing wall to a<br />
maximum height of 2400 mm<br />
200 x 50 mm Min. Nail to backer block & joist with 2 rows of 3.15 dia x 75 mm<br />
at 150 mm centres and clinch<br />
A<br />
70 mm<br />
MIN.<br />
Bearing.<br />
F9<br />
Min F8 - Durable or<br />
treated timber<br />
(UNIFORM LOADS ONLY).<br />
1200 mm MAX. 1200 mm MIN.<br />
L<br />
1.5 x L<br />
Non Load bearing wall<br />
to a maximum height<br />
of 2400 mm<br />
A<br />
Backer block - Nail with 2 rows of<br />
3.75 dia x 65 mm nails at 150 centres<br />
and clinch<br />
Section A-A<br />
UNIFORM LOADS ONLY<br />
<strong>SmartJoist</strong> blocking<br />
NOTE: <strong>SmartJoist</strong>s<br />
MUST BE PROTECTED<br />
FROM THE WEATHER<br />
<strong>SmartJoist</strong>s may be cantilevered up to 1/3<br />
of their back span.<br />
L/3 MAX.<br />
Example 1200 mm<br />
L<br />
Example: 3600 mm<br />
FOR CANTILEVERS SUPPORTING LOAD BEARING WALLS, SEE DETAILS C1 or C2.<br />
<strong>SmartJoist</strong> <strong>Design</strong> <strong>Guide</strong> 15