GSE350-355 IS Indicator User Manual - Avery Weigh-Tronix
GSE350-355 IS Indicator User Manual - Avery Weigh-Tronix GSE350-355 IS Indicator User Manual - Avery Weigh-Tronix
NOTE: This is a Note symbol. Notes give additional and important information, hints and tips that help you to use your product. 1.2 Installation DANGER: RISK OF ELECTRICAL SHOCK. NO USER SERVICEABLE PARTS. REFER TO QUALIFIED SERVICE PERSONNEL FOR SERVICE. 1.3 Electrical Installation CAUTION: The AC to DC Power Supply power cable must be connected to an earth-grounded electrical outlet. The electrical supply must have a circuit breaker with an appropriate rating to protect from over-current conditions. For your protection, all electrical (110V or 230V) equipment used out of doors or in wet or damp conditions should be supplied from a correctly fused power source and protected by an approved ground fault protection device (RCD, GFCI etc.) IF IN DOUBT SEEK ADVICE FROM A QUALIFIED ELECTRICIAN. 1.3.1 Pluggable Equipment Pluggable equipment must be installed near an easily accessible socket outlet. 1.3.2 Permanently Wired Equipment - Isolator Requirements Permanently connected equipment must have a readily accessible disconnect device incorporated in the fixed wiring such as an isolator or circuit breaker with at least 3mm contact separation. The isolator MUST NOT be installed into the flexible power cable supplied with the unit. The mains supply to the weighing equipment MUST be protected by a 4000A breaking capacity fuse of a suitable current rating (a suitable fuse is a 3A Bussmann type TDC180). These fuses are usually of the sand filled type. 4 Model 350 I.S. and Model 355 I.S. User Instructions
1.3.3 Safe Handling of Equipment with Batteries CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions. ATTENTION: Il y a danger d'explosion s'il y a remplacement incorrect de la batterie, remplacer uniquement avec une batterie du même type ou d'un type équivalent recommandé par le constructeur. Mettre au rebut les batteries usagées conformément aux instructions du fabricant. 1.3.4 Wet Conditions Under wet conditions, the plug must be connected to the final branch circuit via an appropriate socket / receptacle designed for washdown use. Installations within the USA should use a cover that meets NEMA 3R specifications as required by the National Electrical Code under section 410-57. This allows the unit to be plugged in with a rain tight cover fitted over the plug. Installations within Europe must use a socket which provides a minimum of IP56 protection to the plug / cable assembly. Care must be taken to make sure that the degree of protection provided by the socket is suitable for the environment. 1.4 Routine Maintenance IMPORTANT: This equipment must be routinely checked for proper operation and calibration. Application and usage will determine the frequency of calibration required for safe operation. Always turn off the machine and isolate from the power supply before starting any routine maintenance to avoid the possibility of electric shock. Make sure that it is placed securely on a flat and level surface. Model 350 I.S. and Model 355 I.S. User Instructions 5
- Page 1 and 2: Model 350I.S. and Model 355I.S. Ins
- Page 3 and 4: Table of Contents Chapter 1 General
- Page 5: 1 General information and warnings
- Page 9 and 10: 1.8 FCC and EMC Declarations of Com
- Page 11 and 12: 2 Installation The Model 350/355 I.
- Page 13 and 14: 2.3.1 Model 350 I.S. Figure 2.1 Mod
- Page 15 and 16: 2.4 AC and DC Powered 2.4.1 DC Oper
- Page 17 and 18: 3 Display and Keypad 3.1 Display Th
- Page 19 and 20: Key Press Weigh Mode Count Mode Bac
- Page 21 and 22: 3.2.3 Weigh Mode Functions The Mode
- Page 23 and 24: 4 Operation The Model 350 I.S. and
- Page 25 and 26: To enter the date from the Enter~da
- Page 27 and 28: 4.6 Percentage Checkweigh This feat
- Page 29 and 30: Example: Target of 20 2a. Press [PR
- Page 31 and 32: m DISPLAY READS > 2 . 2c. Press [PR
- Page 33 and 34: 4.9.1 Enter a Target Pressing [TARE
- Page 35 and 36: 4.9.4 Discharge Example With a syst
- Page 37 and 38: Annunciators Status Annunciator Sta
- Page 39 and 40: 4.11.2 Start Checkweighing The chec
- Page 41 and 42: 4.12.3 Target Deviation Checkweighi
- Page 43 and 44: 5 Troubleshooting The Model 350/355
- Page 45 and 46: 6 Specifications Performance Full S
- Page 48: Avery Weigh-Tronix USA 1000 Armstro
NOTE: This is a Note symbol. Notes give additional and important information, hints<br />
and tips that help you to use your product.<br />
1.2 Installation<br />
DANGER: R<strong>IS</strong>K OF ELECTRICAL SHOCK. NO USER SERVICEABLE<br />
PARTS. REFER TO QUALIFIED SERVICE PERSONNEL FOR SERVICE.<br />
1.3 Electrical Installation<br />
CAUTION: The AC to DC Power Supply power cable must be connected to an<br />
earth-grounded electrical outlet. The electrical supply must have a circuit<br />
breaker with an appropriate rating to protect from over-current conditions.<br />
For your protection, all electrical (110V or 230V) equipment used out of doors or<br />
in wet or damp conditions should be supplied from a correctly fused power<br />
source and protected by an approved ground fault protection device (RCD,<br />
GFCI etc.)<br />
IF IN DOUBT SEEK ADVICE FROM A QUALIFIED ELECTRICIAN.<br />
1.3.1 Pluggable Equipment<br />
Pluggable equipment must be installed near an easily accessible socket outlet.<br />
1.3.2 Permanently Wired Equipment - Isolator Requirements<br />
Permanently connected equipment must have a readily accessible disconnect device<br />
incorporated in the fixed wiring such as an isolator or circuit breaker with at least 3mm<br />
contact separation.<br />
The isolator MUST NOT be installed into the flexible power cable supplied with the unit.<br />
The mains supply to the weighing equipment MUST be protected by a 4000A breaking<br />
capacity fuse of a suitable current rating (a suitable fuse is a 3A Bussmann type<br />
TDC180). These fuses are usually of the sand filled type.<br />
4<br />
Model 350 I.S. and Model <strong>355</strong> I.S. <strong>User</strong> Instructions