Marvair SP-SC Air.pdf - Marlow-Hunter, LLC
Marvair SP-SC Air.pdf - Marlow-Hunter, LLC
Marvair SP-SC Air.pdf - Marlow-Hunter, LLC
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Fan Mode Set Up<br />
SeaMach Reverse Cycle <strong>Air</strong> Conditioners<br />
In the Fan Mode, there are three selections – Manual, Auto and Continuous. Select Manual, Auto or<br />
Continuous by pressing the top or the bottom of the touch pad.<br />
In the Manual mode, a constant fan speed is selected; the desired fan speed is selected in Fan Speed<br />
Selection Set Up (next screen).<br />
If Auto is selected, the fan will automatically change speeds, depending on the difference between the<br />
temperature in the cabin and the set point temperature. The fan will start on maximum speed. As the<br />
cabin temperature approaches the set point temperature, the fan will slow down to the minimum set<br />
speed. The minimum speed is selected in Fan Speed Selection (next screen). Auto is the recommended<br />
Fan Mode selection.<br />
In Continuous mode, the compressor will cycle on and off depending on the temperature in the cabin,<br />
but the fan will run continuously.<br />
To move to Fan Speed Set Up, press on the right side of the touch pad.<br />
Fan Speed Set Up<br />
In the previous Fan Mode, either Manual or Auto was selected.<br />
If Manual was selected, set the desired fan speed by pressing the top or bottom of the touch pad. In this<br />
mode the fan remains at a constant speed and does not vary. The number indicates the fan speed on a<br />
scale from 1-28.<br />
If Auto, was selected in the Fan Mode, now select the Low Fan Speed. The lower the setting, the longer<br />
it takes to reach the set point temperature. The number indicates the fan speed on a scale of 1-28.<br />
To move to Temperature Scale Set Up, press on the right side of the touch pad.<br />
SeaMach Owner’s Manual 5/05 Page 8 of 24