HME system 20 drive-thru timer system operations manual.pdf

I. UNDERSTANDING THE SYSTEM 20A TIMER
A. Definitions of Terms
Control display
Data display
Reset switch
Printer
Keypad
Special function keys
Figure 1. System 20A Control Unit
1. Equipment Definitions
Control Unit - A white, wall-mounted unit with keypad, display panels and
printer. It is the main component of the system.
Control Unit Features:
Control Display - The large display on the control unit, that shows the time
a vehicle is present in various places in the drive-thru area. During times of
no drive-thru activity, either all zeros, certain average times or the last
vehicle time can be displayed.
Data Display - A small display on the control unit, above the keypad, which
shows the keypad entries when the system is being set up. The current date
and time will appear on the upper line of this display during operation. The
display indicates the presence of a vehicle at any of the four possible detection
points with a V1, V2, V3 or V4 on the lower line of the display.
Keypad - A pad of 19 touch-sensitive keys on the control unit. The keypad
has numbered keys 0 through 9 and special function keys, to enter setup
information into the system and to request printed reports.
Printer - A built-in thermal printer, on the control unit, for printing reports.
Reset Switch - A switch on the left side of the control unit, for resetting the
displays
Loop - An underground loop located at the menu board and/or service
window. Vehicles stopping over this loop can be recorded by the system.
Remote Display - A display unit located away from the control unit, such
as in the cashier booth or manager’s office, showing the same type of
information shown on the control display.
1