HME system 20 drive-thru timer system operations manual.pdf

Step 11: action result
To select a detection delay time of Ø, 1, 3 or
4 seconds at detection point 4, press the
number key, then press ENTER. For a 2
second delay time, press the ENTER key
to select the default and continue.
Audio Lane1 On Y/N?
Enter 1=Yes, Ø=No:Ø
Step 12: action result
If you want to measure the greeting delay
time in lane 1, press key 1, then press ENTER.
If not, press the Ø key, then press ENTER.
Audio Lane2 On Y/N?
Enter 1=Yes, Ø=No:1
Step 13: action result
(Scenario 4 only.) If you want to measure the
greeting delay time in lane 2, press ENTER.
If not, press the Ø key, then press ENTER.
Pullout Time Setting
Que Max (Ø-180s):12Ø
Step 14: action result
To leave the queue pullout time at 120 seconds,
press ENTER. To change the que pullout time,
press the number keys, then press ENTER.
Pullout Time Setting
Serv Window Idle:6Ø
NOTE: To account for pullouts, the system will discard the times for a vehicle if the
conditions described in both Steps 14 and 15 are met. If a car does not arrive at
the service window within 120 seconds (or whatever other queue pullout time you
selected) after leaving the menu board; and if a car does not arrive at the service
window within 60 seconds (or whatever other service window time you selected)
after the last car left.
Step 15: action result
To leave the service pullout time at 60 seconds,
press ENTER. To change it, press the
number keys, then press ENTER.
Ø6/Ø7/95 16:Ø4:Ø2
Enter command or ESC
This completes the Installer System Setup.
45