HME system 20 drive-thru timer system operations manual.pdf

Step 5: action result
To select a detection delay time of 1, 2, 3
or 4 seconds at detection point 1, press
the number key, then press ENTER. For a
Ø second delay time, press the ENTER key
to select the default and continue.
Pt 2, Ø=Off,1=+,2=--,
3=Closure (DetPt2):2
NOTE: Not all detection points are used in every scenario. Press ENTER to skip
any detection point not being used. Refer to pages 3 and 4.
Step 6: action result
To enter the type of vehicle detector
signal used at detection point 2, press
one of the following number keys, then
press ENTER. Refer to detection types
listed under Step 4.
Detection Pt 2
DetDelayTimeØ-9sec:2
Step 7: action result
To select a detection delay time of Ø, 1,
3 or 4 seconds at detection point 2, press
the number key, then press ENTER. For a
2 second delay time, press the ENTER
key to select the default and continue.
Pt 3, Ø=Off,1=+,2=--,
3=Closure (DetPt3):2
Step 8: action result
To enter the type of vehicle detector
signal used at detection point 3, press
one of the following number keys, then
press ENTER. Refer to detection types
listed under Step 4.
Detection Pt 3
DetDelayTimeØ-9sec:Ø
Step 9: action result
To select a detection delay time of 1, 2, 3
or 4 seconds at detection point 3, press
the number key, then press ENTER. For a
Ø second delay time, press the ENTER
key to select the default and continue.
Pt 4, Ø=Off,1=+,2=--,
3=Closure (DetPt4):2
Step 10: action result
To enter the type of vehicle detector
signal used at detection point 4, press
one of the following number keys, then
press ENTER. Refer to detection types
listed under Step 4.
Detection Pt 4
DetDelayTimeØ-9sec:2
44