HME system 20 drive-thru timer system operations manual.pdf
HME system 20 drive-thru timer system operations manual.pdf
HME system 20 drive-thru timer system operations manual.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
F. Display Setup<br />
The display setup is for selecting the kind of data to be shown on the control unit<br />
display and any remote display units. The control unit is always designated<br />
display number 1. Each remote display unit was assigned a number, 2<br />
through 4, by the System <strong>20</strong>A installer at the time of installation. Only 3<br />
remote units can be used with the System <strong>20</strong>A.<br />
Step 1: action result<br />
Complete the instructions on page 11.<br />
Press the SETUP, 3 and ENTER keys<br />
to get the display to the right.<br />
DisplayConfig:Ø=Done<br />
Display # (1--4) :Ø<br />
NOTE: If you need to exit the Display<br />
Setup mode and return to the<br />
Timer Configuration display, press<br />
the ESC key.<br />
Step 2: action result<br />
To enter the number of the control display<br />
(1) or remote display (2--4) now being programmed,<br />
press the respective number key,<br />
then press ENTER.<br />
Example entry : 2<br />
Display 1 Setup<br />
Time event (1--9):1<br />
Scenario 2 has 5 timing events.<br />
The number of timing events<br />
varies with other scenarios.<br />
<strong>20</strong>