HME system 20 drive-thru timer system operations manual.pdf
HME system 20 drive-thru timer system operations manual.pdf
HME system 20 drive-thru timer system operations manual.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
C. Printer Setup<br />
The Printer Setup mode allows the System <strong>20</strong>A to be set up for use with its internal<br />
printer, an external, serial printer or no printer at all.<br />
NOTE: An external, serial printer can be purchased as an accessory to the System<br />
<strong>20</strong>A. For ordering information, see page 39. The printer cable connects to a 9-pin,<br />
RS232 connector on the top of the System <strong>20</strong>A control unit.<br />
Step 1: action result<br />
Complete the instructions on page 11.<br />
Press the SETUP, 1 and ENTER keys<br />
to get the display to the right.<br />
Setup Printer, Ø= None<br />
1=Intrnal, 2=Remote:1<br />
NOTE: If you need to exit the Printer Setup<br />
mode and return to the Timer Configuration<br />
display, press the ESC key.<br />
Step 2: entry result<br />
Press key 1 or 2 to indicate whether an<br />
internal or remote (external) printer will be<br />
used for System <strong>20</strong>A printouts. Press the<br />
Ø key if no printer will be used. Then press<br />
ENTER to return to the Timer Configuration<br />
display.<br />
Timer Configuration<br />
(1--1Ø) or Ø=Done : 1<br />
This completes the Printer Setup. Other Timer Configuration settings can be<br />
selected by pressing any of the number keys shown on Table 2, page 12. Press<br />
the ESC key to return to the Enter Command display on page 11.<br />
17