HME system 20 drive-thru timer system operations manual.pdf
HME system 20 drive-thru timer system operations manual.pdf
HME system 20 drive-thru timer system operations manual.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
E. Printer Paper<br />
A special type of thermal paper is used for the System <strong>20</strong>A printer.<br />
To order paper, refer to ordering details in section VI, page 39 of this <strong>manual</strong>.<br />
TO LOAD PRINTER PAPER<br />
❑ Remove the tape from the paper roll and<br />
unroll 2 inches of paper. Be certain there is<br />
a straight edge on the paper.<br />
❑ Hold the roll in your left hand, as shown on<br />
figure 12.<br />
❑ Hold the paper against the blue plastic and<br />
slide it down until it enters the paper-feed<br />
slot.<br />
❑ Move the paper slightly left and right, and<br />
push it as far as possible into the slot.<br />
❑ Hold the paper in place.<br />
❑ Push the PAPER FEED key. Paper should<br />
begin to be pulled into the printer.<br />
❑ Continue pushing the PAPER FEED key until<br />
the paper appears at the paper-cutter slot<br />
(minimum of three times).<br />
Figure 12.<br />
Loading Printer Paper<br />
❑ If paper is not being pulled into the printer,<br />
it is not properly aligned, or was not far<br />
enough into the printer.<br />
❑ If the printer malfunctions, wait 30 seconds.<br />
Then press the ESC key repeatedly until the<br />
date and time appear on the data display,<br />
then press the PAPER FEED key. Pull on the<br />
paper to be certain it feeds freely.<br />
9
Change language