Component Catalogue - Lifting Systems 07/05/2013 - KLH
Component Catalogue - Lifting Systems 07/05/2013 - KLH
Component Catalogue - Lifting Systems 07/05/2013 - KLH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
V I S I B L E F A C T O R Y F I T T E D L I F T I N G S Y S T E M S F O R W A L L E L E M E N T S<br />
ILLUSTRATION OF VISIBLE FACTORY FITTED LIFTING SYSTEMS FOR WALL ELEMENTS (W-SYSTEM)<br />
EDGE DISTANCES W-SYSTEM<br />
The following illustrations identify the edge distance requirements for lifting holes within the wall panel.<br />
Standard Half Lap Slope cut<br />
½ ½<br />
130<br />
130<br />
80<br />
130<br />
<strong>KLH</strong> wall element<br />
80<br />
Ø30<br />
<strong>KLH</strong> wall element<br />
Ø30<br />
<strong>KLH</strong> wall element<br />
Ø30<br />
The holes for lifting slings will be incorporated into the fabrication drawings by <strong>KLH</strong>UK.<br />
The position of the hole for the lifting sling will depend on the edge distance, the balance point and the handling position<br />
of the <strong>KLH</strong> element. The specific lifting system type will normally be specified by <strong>KLH</strong>UK.<br />
The maximum distance between 2 lifting slings is 6,000mm.<br />
0 8